Turbo Air Speeds up the Pace of Innovation
Undercounter
Refrigerators & Freezers
Installation and Operation Manual
Please read this manual completely before attempting to install or operate this equipment!
REFRIGERATORS
MUR-28
MUR-36
MUR-48
MUR-60
MUR-72
FREEZERS
MUF-28
MUF-36
MUF-48
MUF-60
www.turboairinc.com
CONTENTS
PAGE
SPECIFICATIONS
SERIAL NUMBER
INSTALLATION OF CASTERS
INSTALLATION OF DRAIN PAN
HOW TO CLEAN THE PAN SUPPORTER
INSTALLATION
CLEANING & CAUTION
BASIC OPERATION
REVERSIBLE DOOR INSTRUCTIONS
TROUBLESHOOTING
STAINLESS STEEL EQUIPMENT CARE AND CLEANING
WARRANTY
SPECIFICATIONS
UNDERCOUNTER REFRIGERATORS
2
2
3
4
5
6
7
8
9-12
13
14-15
16-18
MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT
MUR-28
MUR-36
MUR-48
MUR-60
MUR-72
1/5 115V/60Hz R-134A 3.3A 163lbs
1/4 115V/60Hz R-134A 6.6A 199lbs
1/3 115V/60Hz R-134A 6.5A 246lbs
1/3 115V/60Hz R-134A 8.9A 282lbs
1/2 115V/60Hz R-134A 9.9A 352lbs
UNDERCOUNTER FREEZERS
MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT
MUF-28
MUF-36
MUF-48
MUF-60
1/3 115V/60Hz R-134A 5.3A 163lbs
1/3 115V/60Hz R-134A 6.0A 187lbs
1/2 115V/60Hz R-134A 8.3A 246lbs
1/2 115V/60Hz R-134A 9.0A 282lbs
SERIAL NUMBER
The serial number is located on the rating label which is on the left interior wall.
Please retain the unitʼs serial number for service purpose.
2
INSTALLATION OF CASTERS
1) Screw the caster (in rear side) and the caster brakes (in front side) by using
caster wrench.
2) Use the caster shims to level the cabinet, if necessary, by inserting them to
stems of the casters.
ROTATION CASTER (2EA)
CASTER (WITH BRAKE) (2EA)
3
INSTALLATION OF DRAIN PAN
1) In damp season, when the drain water overflow the drain pan, remove the
drain pan and pour the water away. And then set the drain pan back up as
below drawing please (Model : MST-28, MST-28-12, MUR-28, MUF-28).
MST-28, MST-28-12
MUR-28, MUF-28
4
HOW TO CLEAN THE PAN SUPPORTER
1) Remove the Guide Pans and Pans. Then pull out the Pan Supporter. Clean
the pan supporter and reinstall in place.
MODEL
MST-28, MST-48
MST-60, MST-72
MST-28-12, MST-48-18
MST-60-24, MST-72-30
5
INSTALLATION
1. GOOD AIR CIRCULATION
- Be sure to avoid any object which may stop the air flow
- Be sure that there is ample air space so that air can flow through the rear of the unit
- Turbo Air recommends that the rear of the unit be no less than 5 inches from the wall
2. PLACE ON STRONG GROUND
- Be sure the location chosen has a floor strong enough to support the total weight of
the cabinet and contents
3. DO NOT PLACE NEAR HEAT
- Be sure to avoid hot corners and locations near stoves
- High ambient temperature will make much lower cooling efficiency
4. INDOOR USAGE ONLY
- Be sure to install this unit indoor, so it will not get wet from the rain
5. STABILIZING
- Make sure the unit is installed in a stable condition with the front wheels locked
while in use
6. LEVELING
- Be sure that the unit is level from front to back and side to side
7. UNIT SHOULD BE ON DEDICATED OUTLET
6