TTE Technology 32S327 User Manual

: , BOM

赵晓强

数字签名人赵晓强

DN：cn=赵晓强， c=<无>，o=TCL多

媒体，ou=平面设计部日期：2018.07.02

16:13:51 +08'00'

(BRAND NAME)

B.O.M.

70-F6ST14-QSG1C

User Manual

S325/S327 MST14FA

TCL-NA

2018-04-25

(TO):

(TYPE OF JOB.):

ii) iii)

iv)

Silk Screen Pri nt in g

(SCALE)

(SIZE)

(COLOUR)

IQC

1:1

四色印刷。

PMC

Wash Pr in ti ng

Four-Colo ur Pri nt in g

材质：100g书纸。

折页，骑马钉。红色封面是PANTONE 186C

放入附件袋红色封面向上可见

Spraying Pain t

Plastic Co lo ur

Others

TCL

PREPARED BY

CUSTOMER

CHECKED BY

ODF

ODF DATE:

CHECKED BY:

REVIEWED BY:

Hi! Let’s get started.

3-Series S321/S325/S327

DO NOT RETURN TO STORE

WE ARE READY TO

HELP

with any questions

TAKE CARE WHEN REMOVING THE TV

TCL SUPPORT:

www.tclusa.com/support

1-877-300-8837

Important Information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualiﬁed service personnel.

This symbol indicates “dangerous voltage” inside the product that presents a risk of electric shock or personal injury.

WARNING

To reduce the risk of ﬁre or electric shock, do not expose this product to rain or moisture. This product should not be exposed to dripping or splashing. No objects ﬁlled with liquids, such as vases, should be placed on the apparatus.

This symbol indicates that this product incorporates double insulation between hazardous main voltage and user accessible parts. When servicing, use only identical replacement parts.

This symbol indicates important instructions accompanying the product.

WARNING

The TV is unstable if it is not properly attached to the base or mounted to the wall. Please follow the base or wall mounting instructions provided in the User’s Guide to ensure your safety.

Warning: The batteries shall not be exposed to excessive heat such as sunshine, ﬁre or the like.

Refer to the identiﬁcation/rating label located on the back panel of your product for its proper operating voltage.

Cable TV Installer:

Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, speciﬁes that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

Important:

the TV on soft carpeting or similar surface because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced lifetime from overheating. To assure adequate ventilation for this product, maintain a spacing of 1 inch from the top and side of the TV receiver and 2 inches from the rear of the TV receiver and other surfaces. Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being accidentally tipped over, pushed o, or pulled o. This could cause personal injury and/or damage to the TV. Refer to the Important Safety Instructions on the next page. The Power button on this TV and your remote control puts the TV into a very low-power standby mode but will not completely turn the power o. In order to completely shut the power o, you will need to disconnect the power cord from the outlet. The mains plug/appliance coupler is used to completely turn o the device. If you prefer to completely turn o the device, you should install the TV in a manner that allows you to disconnect the power cord when desired.

This television is a table model and is designed to sit on a ﬁrm, ﬂat surface. Don’t place

Product Registration

Please register your TCL TV purchase on-line at www.tclusa.com. It will make it easier to contact you should it ever be necessary. Registration is not required for warranty coverage.

This reminder is provided to call your attention to Article 820-40 of the National

Product Information

Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach it here and record the serial and model numbers in case you need them. These numbers are located on the product. Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Keep the apparatus at least 8 inches away from the human body.

Input Signal Compatibility

Antenna/Cable Composite Video HDMI

For the best viewing experience, remove the energy guide label from the TV front panel or TV screen before use.

Model No.

Purchase Date

480i, 480p, 720p, 1080i (NTSC, ATSC, and QAM formats) 480i, 576i 480i, 480p, 720p/60Hz, 1080i/60Hz, 1080p/60Hz, 576i/p, 1080i/p/50Hz

Serial No.

Dealer/Address/Phone

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus(including ampliﬁers) that produce heat.

9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

10. WARNING: Please refer the information on exterior bottom enclosure for electrical and safety information before installing or operating the apparatus.

11. WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.

12. When not in use and during movement, please take care of the power cordset, e.g. tie up the power cordset with cable tie or something like that. It shall be free from sharp edges and the like that can cause abrasion of the power cordset. When put into use again, please make sure the power cordset being not damaged, If any damages found, please look for the service person to replace the power cordset speciﬁed

by the manufacturer or have the same characteristics as the original one.

13. No naked ﬂame sources, such as lighted candles, should be placed on the apparatus. Unplug this apparatus during lightning storms or when unused for long periods of time.

14.

15. Only use attachments/accessories speciﬁed by the manufacturer.

16. Use only with the cart, stand, tripod, bracket, or table speciﬁed by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the

cart/apparatus combination to avoid injury from tip-over.

17. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate

normally, or has been dropped.

18. For safe operation of the apparatus, observe these installation requirements: Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall. Keep at least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such as; newspapers, curtains, table-cloths or any other objects. Do not expose the apparatus to any external

heat sources. Do not place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose the device to high levels of humidity or to any possible sources of moisture. When disposing of used

batteries

from the remote control, consult local regulations regarding proper disposal.

19. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system

is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead in wire to an antenna-discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

See following example:

ELECTRIC SERVICE EQUIPMENT

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PARTH)

+ 10 hidden pages