
HONDA RIDGELINE NOISE REDUCTION INSTALLATION
Roll cover to the front: Begin by unlatching the rear
1 2
header and start rolling the cover to the front, stopping
at the rst cross support tube.
Apply nylon loop strip: With the split in the nylon loop
3
4
ends still facing up. Peel the plastic backing away from
the 1.00” x 47” nylon loop strip and apply it to the cross
support tube. Position the strip between the two nylon
end pieces. See picture below. Next reattach the
cross support tube back in place on the cover. Make
sure the nylon strip that was just applied is facing the
cover. Continue to roll cover and repeat step two and
three for the front cross support tube.
Remove cross support tubes: Detach the rear cross
support tube. Next clean the cross support tube with
alcohol. Lay the detached cross tube on a at surface.
Rotate the tube so that the nylon loop on ether end has
the separation split facing up. See picture below.
Rotate tube until
the split in the nylon
loop is showing.
Nylon loop end
pieces
.
Apply polyester hook to the rails: After the cross
support tubes are reattached to the cover, roll the cover
closed stopping at the cross support tube. Next attach the
1” x 4” long polyester hook to the driver and passenger
side rail. This piece of polyester will be applied to the side
rail at the exact location where the cross support tube
lays on the rail. See the picture bellow. Note: Before
applying polyester hook, clean the area on the side
rail with alcohol.
Align the end of the nylon strip to the inside edge of nylon end piece. Be
sure to center the nylon strip the full length of the tube.
by TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877- 878-9336 • Fax: (605) 664-9304 www.truxedo.com
Align the edge of the 4” polyester hook strip to the edge of the side rail.
P/N 1117347 Rev B

HONDA RIDGELINE NOISE REDUCTION INSTALLATION CONT.
Apply nylon loop to cross support tube attachments:
5
Next apply the 1.5” x 3” long nylon loop patches over the
cross support tube attachments. See picture below.
Apply nylon loop to cross support tube attachments:
6
Continue to roll cover closed and repeat step four and
ve on the last cross support tube.
1
2
3
Replacement Parts List
Item Part # Description
1. 1117344 NYLON LOOP_BLACK_1.00 X 47_ADH
2. 1110934 NYLON LOOP_BLACK_1.5 X 3_ADH
3. 1117435 POLYESTER HOOK_BLACK_1” X 4”_ADH
by TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877- 878-9336 • Fax: (605) 664-9304 www.truxedo.com
P/N 1117347 Rev B