TruTrak Digitrak Ref User Manual

DigiTrak Quick Reference GPS MODE

When

AP is …

Initially Powered-On

Disengaged

Engaged, holding a selected Ground Track

Engaged, in NAV mode

← Disengaged,

in Control Stick Mode

↑ Engaged,

in Constant-turn Mode

Display Shows…

Flashing

– – –

OFF

Selected Ground Track

Alternating

ground track

and

– F –

– 0 –

Electronic DG

To … … Perform the action

Allow Gyro to Center

Engage Autopilot

Manually Center Gyro

Disengage Autopilot

Modify selected Ground Track in 1 degree increments Hand-fly aircraft to a different direction

Enter a constant-rate turn

Enter NAV mode

Leave NAV mode

Capture a new selected Ground Track

Stop the turn and capture a new Ground Track to be held

Hold Aircraft Still for approximately 10 seconds as long as display is flashing Click to capture and hold present heading

– OR –

Press and Hold Control Stick Button. After 1 second, the Control-Stick Mode goes into effect (see

With aircraft heading held and hold both (Display will show Hold for about ten seconds, and then release both buttons. Click

- OR Click Control Stick Button

Click or once per degree

Press and Hold Control Stick Button. After 1 second, the Control-Stick Mode is in effect (see

Hold Constant-turn mode is in effect (see

Press (Note: do not hold buttons down more than one sec).

Depending on position relative to course line, autopilot will steer for an intercept of up to 45 degrees.

Click Click Control Stick button to disengage, OR Press and Hold Control Stick Button. After 1 second, the

Control-Stick Mode is in effect (see While holding Control Stick Button, hand-fly to desired Ground Track. Level the wings, then release Control Stick Button

Click

IMPORTANT!

completely still, press

and simultaneously.

–| – |– while centering.)

or for at least 1 sec, then release.

and at the same time, then release

or to leave NAV mode, OR

← below).

↑ below).

← below).

DigiTrak Quick Reference MAGNETIC BACKUP MODE

When

AP is …

Initially Powered-On

Disengaged

Engaged, holding a Magnetic Heading

← Disengaged,

in Control Stick Mode

↑ Engaged,

in Constant-turn Mode

Display Shows…

Flashing

– – –

–|–|–

– – –

Moving

–| – –

to left or right

To … … Perform the action

Allow Gyro to Center

Engage Autopilot

Manually Center Gyro

Disengage Autopilot

Modify magnetic heading in 1-degree (approx.) increments Hand-fly aircraft to a different direction

Enter a constant-rate turn

Capture a new selected Heading

Stop the turn and capture a new Magnetic Heading to be held

Hold Aircraft Still for approximately 10 seconds as long as display is flashing Click to capture and hold present heading

– OR –

Press and Hold Control Stick Button. After 1 second, the Control-Stick Mode goes into effect (see

With aircraft heading held and hold both (Display will show – Hold for about ten seconds, and then release both buttons. Click

- OR Click Control Stick Button

Click or once per degree

Press and Hold Control Stick Button. After 1 second, the Control-Stick Mode is in effect (see

Hold Constant-turn mode is in effect (see

While holding Control Stick Button, hand-fly to desired heading. Level the wings, then release Control Stick Button

Click

IMPORTANT!

completely still, press

and simultaneously.

| – |– while centering.)

or for at least 1 sec, then release.

← below).

↑ below).