Triumph Trophy, Trident Sprit, Triden, Daytona, Tiger Alarm Fitting And Operating Instructions

Alarm Fitting and Operati

ng

I

struct

ions

Trophy

. Dayto

na.

Triden • Trid

ent

Spri t . Tiger

Kit

Contents

Alarm Fitting and

~perating

Instructions

Description Qty
Control

LED Warning Lamp . . . . . . . . . . 1

M5 SelfTapping Screw . . .. . . . 1

M4 Nuts 4
Warning Label 2

Locknut M5 . . . . . . . . . . . . . . . . . 1

Box.

. . . . . . . . . . . . . . . . 1

Description
Speaker 1
Retaining Band 1
Pedestal 2
Flat Washers 2
Screw M5 1

Qty

Fitting Instructions

1. Unlock and remove the motorcycle seat. Remove the tool kit.

2. Disconnect the motorcycle battery, negative lead (black) first.

3. On

all except Tiger, remove the body side panels from the frame as follows:

a. Unbolt the grab rail (where fitted).

b. Remove the screws securing the side panels to the frame. The side panels are further retained by 4 "push
fit" bayonets on both sides which locate into grommets in the frame. Todetach the side panels, support the
panels and gently pull each bayonet horizontally from its grommet.
On Tiger, remove the screws securing the seat end cap to the frame/body and remove the end cap.
Release the screws securing the right hand lower fairing panel to the fuel tank and cockpit. Remove the
panel.