Tri-Tronics NightRazor Spotlight User Manual

Service
Do not open the NIGHTRA ZOR.

The battery is not eld replaceable,
and no service can be done in the eld.
Any service of the light must be done
by the Tri-Tronics Service Department
in Tucson, AZ.

Battery Warnings

If these guidelines are not followed, the internal
lithium-ion battery may experience a shortened life
span or may present a risk of damage to the device,
re, chemical burn, electrolyte leak, or injury.

Do not leave the device exposed to a heat source

►

or in a high-temperature location, such as in the
sun in an unattended vehicle. To prevent damage,
remove the device from the vehicle or store it
out of direct sunlight, such as in the glove box.

Contact your local waste

►

dispose of the device/battery in accordance with
applicable local laws and regulations.

In addition, the NIGHTRAZOR uses

►

non-user-replaceable battery. Do not remove
or attempt to remove the non-user-replaceable

battery.

When storing the device for a limited length of

►

time, store within the following temperature
range: from -4˚F to 104˚F (from -20˚ to 40˚C).
When storing the device for an extended time,
store within the following temperature range:
from 32˚F to 77˚F (from 0˚ to 25˚C).

disposal department to

an internal,

Cleaning the Lens

Clean the lens with warm water, soap,

►

and a soft cloth.

Do not use acetone or any other

►

industrial cleaner on the lens.

Do not operate the device outside of the

►

following temperature range: from -4˚ to 140˚F
(from -20˚ to 60˚C).

Recharge the device within the following

►

temperature range: from 32˚F to 113˚F (from 0˚
to 45˚C).

Do not recharge the battery outside of the

►

device or disassemble the battery.
Do not attempt to replace the battery for the

►

NIGHTRAZOR. It is not eld replaceable.

Health Warning

This product, its packaging, and its components
contain chemicals known to the State of
California to cause cancer, birth defects, or
reproductive harm. This notice is provided
in accordance with California’s Proposition

65. See www.garmin.com/prop65 for more
information.

FCC Compliance

This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation. This equipment has
been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and may cause harmful interference to
radio communications if not installed and used in
accordance with the instructions. However, there
is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one of the following
measures:

Reorient or relocate the receiving antenna.

►

Increase the separation between the equipment

►

and the receiver.
Connect the equipment into an outlet that is on

►

a different circuit from the device.
Consult the dealer or an experienced radio/TV

►

technician for help.

This product does not contain any user-serviceable
parts. Repairs should only be made by an

authorized service center. Unauthorized repairs or
modications could result in permanent damage to
the equipment, and void your warranty and your
authority to operate this device under Part 15
regulations.

Warranty

Tri-Tronics warrants the NIGHTRAZOR, when
subject to normal and proper use, to be free from
defects in materials and workmanship for either 2
years from the date of purchase from Tri-Tronics or
one of its authorized dealers. (See the Tri-Tronics
website for complete conditions.)

Product Information

www.tritronics.com

Product Support and Customer Service

Email: [e-mail]
Phone: [phone]

General Business

Phone: [phone]
Fax: [phone]

Address

Tri-Tronics, Inc.
1705 S. Research Loop
Tucson, AZ 85710

1261408B

CORDLESS SPOTLIGHT

OWNERS MANUAL

Light Settings

Adjusting the light – Off (1) is all the

►

way back (counter clock-wise) on the
intensity knob. Super bright (5) is all
the way forward (clock-wise). There
are clicks in between for low (2)
medium (3) and high (4).

S-O-S ash – Turn the intensity knob

►

to low. Turn the intensity knob to
medium and back to low 3 times
quickly. The light ashes in the S-O-S
pattern. You can turn the intensity
knob to adjust the brightness, and
it will continue to ash. To stop the
S-O-S ash, turn the intensity knob
back to the off setting.

Strobe ash – Turn the intensity

►

knob to super bright. Then turn the
intensity knob to high and back to
super bright 3 times quickly. You can
turn the intensity knob to the level
of brightness you prefer (at the low
setting, the light is steady). To turn it
off just turn the intensity knob to the
Off setting (1).

1

2

3

4

5

Battery Charging

Always switch the NIGHTRAZOR

►

off before charging.

Fully charge the NIGHTRAZOR

►

prior to using.

In use – The NIGHTRAZOR will

►

make 4 short ashes every 60 seconds
to notify you of a low charge.

At this point, you still have at least

►

12 minutes of charge left on the high
setting. To make the battery last longer
adjust the light to a lower setting.

The NIGHTRAZOR has LED lights

►

that indicate battery charge level.
These are visible inside the rim of the
optical lens at about the 10:00 o’clock
position. (Do not shine the light in
your eyes, it is bright!)

Red ashing LED – Indicates the

►

light will not work. Turn the intensity
knob to the off position and place the
NIGHTRAZOR on the charger for
a full charge (it takes under 4 hours).

Battery Life
The chart below shows the typical battery life for the NIGHTRAZOR.

Brightness Mode Normal –

Low

Medium

High

Super Bright

Steady Light

48.0 hours 96.0 hours

16.0 hours 32.0 hours

7.3 hours 14.6 hours

2.8 hours 5.6 hours

While charging, the red LED is solid.

►

The NIGHTRAZOR is fully charged
when the green LED is solid.

The NIGHTRAZOR has a separate

►

charging cradle. To purchase additional
accessories, go to www.tritronics.com.

After the NIGHTRAZOR is fully

►

charged, unplug the charging cradle.
Do not keep this unit on the charger.

Flashing –
S-O-S / Strobe

1

Attach the Charging Cradle

Angle the NIGHTRAZOR

➀

forward and place the tab from the
charging cradle over the rim of the
light.

2

1

Tilt the

➁

NIGHTRAZOR back
and gently snap into

2

3

Remove the Charging Cradle

Place your thumb on the back part of the charging cradle

➂

and gently but rmly tilt the NIGHTRAZOR forward with
your other hand.

place. The silver contacts
on the light will align
with the copper contacts
on the charging cradle.