Triton 8000 Showerhead Instruction manual

8000 Series

Showerhead

32mm

Maintenance

Instructions

Installers please note these InstructIons are to be left wIth the user

2180872D - July 2014

8000 SERIES SHOWERHEAD

1

Body

2

3

Removal
button

Lever

Spray
plate

This instruction book covers the operation and
cleaning of the showerhead.

SHOWERHEAD SPRAY POSITIONS

Five showerhead patterns are available.

Adjust the spray pattern by turning the lever
on the showerhead in either direction until the
desired pattern is obtained. These positions are
located at 4, 5, 6, 7 and 8 o'clock, when the
showerhead is in the vertical position.

REMOVING THE SPRAY PLATE

IMPORTANT: Before cleaning, turn off the unit
at the mains supply to avoid the shower being
accidentally switched on.

1 Rotate the spray plate clockwise until it

reaches it's 'stop' position facing the removal
button.

2 Press and hold the removal button in.

3 With the removal button held in, rotate the

face plate clockwise past the removal button
until it stops.

4 Release the removal button and gently pull

the face plate away from the body using the
adjustment lever.

IMPORTANT

Should any difficulty arise when trying
to remove the spray plate (image 4)
DO NOT try to force it out of the body
by hand, or by using tools such as a
screwdriver. Reset the spray plate to the
position shown in image 7 and repeat
steps 1-4 as listed above.

DO NOT remove the inner plate (image

4

5). Removing this, WILL invalidate any
product warranty.