Tripp Lite SUPDU001 User Manual

1111 W. 35th Street • Chicago, IL 60609 USA

Customer Support: [phone] • www.tripplite.com

Owner’s Manual

Connecting an SUPDU001 to the Output of a SmartOnline

™

SU6K, SU10K, SU6000RT3U or SU10KRT3U

Important Safety Instructions! Save These Instructions!

WWAARRNNIINNGG!!

Before connection, make sure that your entire SmartOnline system is OFF

(including transformer modules, where applicable), that all

input and output breakers are
switched OFF and that the system is not connected to AC power.(See SmartOnline Owner’s
Manual.)

WWAARRNNIINNGG!!

SUPDU001 installation and wiring should only be made by a qualified electrician

observing all applicable local, state and national electrical codes and requirements.

• Remove screws and open SUPDU001 case.

• Remove any one of the eight knockouts (either ½ or ¾ inch) around the edge of
SUPDU001 case. Attach a user-supplied conduit connector.

• Attach a second user-supplied conduit connector to the terminal box cover of the
SmartOnline UPS System.

• Connect user-supplied flexible, armored-cable conduit between the SUPDU001 and the
SmartOnline UPS System terminal box.

• Run user-supplied wire through the conduit and make appropriate connections inside the
SUPDU001 and inside the SmartOnline UPS System terminal box.

• Connect the colored wires to the SmartOnline’s terminal block as shown below. The brown
wire can be connected for either 240V output or 208V output. Note: the desired output
voltage MUST match the SmartOnline’s output voltage. (See SmartOnline Owner’s Manual.)

Copyright ©2003 Tripp Lite. All rights reserved. SmartOnline™ is a trademark of Tripp Lite.

200301143 93-2114

Blue

Green Brown

(240V)

Brown
(208V)

or

SUPDU001

Wiring Instructions

UL1788 Listed

UPS Accessory

200301143 93-2114 SUPDU001 Owner’s Manual Revision.qxd 3/19/2003 11:46 AM Page 1

U

L

CUS

L1 G

L2

AC INPUT

208V

240V

INPUT

VOLTAGE SELECT

L3

N

120V 120V

240V

G

208V

L2

N

L1