Tripp Lite SR14 User Manual
SR14
Dual Fan Kit
Please read these instructions carefully and follow
the installation steps in sequence.
Tools Required
Phillips head screwdriver
CLIP NUT INSTALLATION
Clip nuts provide mounting points on 19" rack mount
equipment rails.
Clip nuts have a front or screw side. Consider which
way it should face for ease of access to the screwhead
during component installation. (see figure 1)
Rail
5” Fan Panel
Use this hole
.5”
.625”
.625”
.5”
To remove a clip nut from a rail, insert a flat blade
screwdriver or knife under the tab on the front and
pry up, freeing the retainer ring from the rail.
1. Select the location at which the fan panel will be
installed in the enclosure.
2. Install one clip nut into the top hole at the selected
position and then install another one six holes down.
(see figure 2)
3. Measure from the bottom of the vertical rail to the top
clip nut. Assemble the clip nuts onto the opposite rail
at the measured height.
4. Assemble the Fan Panel to the rails with the 10-32 x 1/2
phillips head screws. (see figure 3)
10-32 x 1/2 phillips
Figure 1
Clip nuts
Rail
Use this hole
Figure 2
Clip nuts
.625”
.625”
.5”
.625”
.625”
.5”
Rails
Manual Part #93-1865
07/09/02 rev. A
Cord
Figure 3
1
SR14
Dual Fan Kit
Parts List
Part Number
SR14
1
2
3
Description Qty.
5” Fan Panel
#10-32 Clip Nut
(Tinnerman #C31758-1032-3B)
#10-32 x 1/2 Philips Head Screw
1
4
4
Manual Part #93-1865
07/09/02 rev. A
2
Loading...