SmartPro Medical-Grade UPS, Line Interactive,
Lithium Battery, 6 Outlets - 230V, 700VA, 450W,
Full Isolation
MODEL NUMBER: SMX700HGL
Line-interactive UPS provides basic battery backup with UL 60601-1 compliance for use in medical
facilities, including patient care areas.
Highlights
●
Lithium battery backup allows
time to save files and safely shut
down during blackouts
●
6 C13 hospital-grade (HG)
outlets provide power to medical
equipment
●
Approved for use within the
Patient Care Vicinity
●
Approved to EN60601-1-2:2015,
4th Edition
●
Alarm and front-panel LEDs
report online, battery, fault and
overload conditions
●
10,000-cycle LiFePO4 battery
lasts up to 30x longer than
comparable SLA batteries
Features
700VA/450W Medical-Grade UPS Allows Time to Back Up Critical Files During a BlackoutThis 230V
SmartPro® hospital-grade UPS is fully compliant with UL 60601-1 regulations when plugged into a
hospital-grade outlet, which makes it ideal for use in medical facilities, including patient care vicinities. It
allows you to work through short power failures, and gives you enough time to safely save files and shut
down your system in case of a prolonged blackout.
Long-Lasting LiFePhos Battery Handles up to 10,000 Cycles with EaseThis UPS system for hospitals
contains a replaceable lithium iron phosphate (LiFePhos) internal battery that provides up to 30 times the
cycle life of traditional sealed lead acid (SLA) batteries. The 6-outlet UPS system provides up to 42
minutes of battery backup at half load and 18 minutes at full load. During normal operation, incoming utility
power keeps the replaceable internal battery fully charged, so backup power will always be available.
Automatic Voltage Regulation (AVR) Corrects Potentially Hazardous Voltage FluctuationsAVR
protects your equipment from incremental hardware damage, data loss and performance problems
caused by brownouts. This UPS for medical equipment can correct brownouts as low as 155V and
overvoltages as high as 274V back to nominal 230V power without drawing on the battery backup needed
to support your equipment during a blackout.
Built-In Isolation Transformer Offers Full IsolationThe isolation transformer with Faraday shield offers
full isolation and removes common mode noise while maintaining full AC surge suppression in all modes.
Cumulative leakage current of all connected equipment is less than 100 microamps.
Connect Your Equipment to 6 IEC 320 C13 OutletsSix C13 hospital-grade outlets provide both battery
backup and surge protector for your mobile medical equipment, such as computers, monitors and lab
equipment. A 340-joule surge suppression rating protects connected components from the harmful effects
of power surges.
Combats Electromagnetic Interference That Can Harm EquipmentVarious electromagnetic and radio
sources found in virtually every home and business can cause disruptive interference on the AC line.
Known as EMI (electromagnetic interference) and RFI (radio frequency interference), this line noise is a
common cause of performance problems and can lead to incremental hardware damage, data corruption
and audio/video transmission problems. This medical-grade UPS system incorporates technology that
filters out disruptive line noise so that it won’t affect your equipment.
Easy-to-Read LEDs and Alarm Report Real-Time UPS and Power StatusFront-panel LED indicators
monitor essential information, such as line power, battery power, overload, voltage regulation and battery
low/replace status. An audible alarm will sound in case of low battery, excessive load and power failure.
Saves Your Files, Even When You’re AwayUSB and DB9 serial ports connect to your computer with the
included cables. These ports communicate with Tripp Lite’s free downloadable PowerAlert® software for
Applications
●
Protect your medical electronics
against power surges,
brownouts and blackouts in
patient care vicinities
●
Operate essential equipment
during short-term power outages
using battery backup power
●
Shut down PCs, monitors,
mobile medical components and
other equipment without data
loss during long-term power
outages
Package Includes
●
SMX700HGL 700VA/450W
SmartPro Medical-Grade UPS,
Tower
●
USB monitoring cable, 1.8 m (6
ft.)
1 / 5
safe, unattended system shutdown and file saves in the event of a prolonged power failure.
Tower Form Factor for Easy Placement on a Nurse’s Station or Mobile Medical CartThe long-lasting
PVC housing fits easily on a desktop, shelf or anywhere else power is needed. The 15-centimeter (sixinch) dongle with hospital-grade C14 plug connects to a properly grounded AC wall outlet.
Specifications
OVERVIEW
UPC Code 037332224804
UPS Type Line-Interactive
INPUT
Rated input current (Maximum Load) 3.6A
Nominal Input Voltage(s) Supported 230V AC
UPS Input Connection Type C14 inlet
UPS Input Cord Length (ft.) 0.50
UPS Input Cord Length (m) 0.2
●
DB9 serial monitoring cable, 1.8
m (6 ft.)
●
Owner’s manual
Recommended Electrical Service 10A 230V
Voltage Compatibility (VAC) 230
Input Phase Single-Phase
OUTPUT
Output Volt Amp Capacity (VA) 700
Output Watt Capacity (Watts) 450
Nominal Voltage Details 230v nominal inverter output voltage
Frequency Compatibility 50 / 60 Hz
Frequency Compatibility Details Automatic frequency selection
Output Voltage Regulation (Line
Mode)
Output AC Waveform (Battery
Mode)
Nominal Output Voltage(s)
Supported
Output Receptacles (6) C13
Individually Controllable Load Banks No
-18%, +8%
PWM sine wave
220V; 230V; 240V
BATTERY
Full Load Runtime (min.) 14.5 min. (450w)
2 / 5
Half Load Runtime (min.) 36 min. (225w)
DC System Voltage (VDC) 36
Battery Recharge Rate (Included
Batteries)
Internal UPS Replacement Battery
Cartridge
Less than 3.6 hours from 10% to 90% (typical, full load discharge)
RBC53L
Battery Access Battery access door allows hot swap battery replacement without powering connected equipment off
Typical Battery Lifespan 3-6 years, depending on usage
Expandable Runtime No
VOLTAGE REGULATION
Voltage Regulation Description Line interactive UPS offers 2 boost levels of brownout correction and a single level of overvoltage adjustment to
maintain usable, computer grade output without consuming battery power over an input voltage range of 155 to
274V AC
Overvoltage Correction Input voltages between 206 and 245V AC are reduced by 9%
Undervoltage Correction Input voltages between 183 and 199 are boosted by 10%
Severe Undervoltage Correction Input voltages between 155 and 182 are boosted by 21%
USER INTERFACE, ALERTS & CONTROLS
Switches Yes, includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions
Audible Alarm 3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous
short beeps) and low battery (continuous tone). Audible Alarm is factory muted for silent operation; Audible alarm
can be restored to indicate power failure, overload conditions and Low Battery events, using our Free PowerAlert
UPS management software.
LED Indicators 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status
SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating 340
EMI / RFI AC Noise Suppression Yes
AC Suppression Response Time Instantaneous
PHYSICAL
Cooling Method Cooling via rear-exit cooling fan
Installation Form Factors Supported
with Included Accessories
Installation Form Factors Supported
with Optional Accessories
Tower
Wallmount ( <a class="productLink" href="// Wall-Mount-Bracket-Installation-Accessories-
for-UPS-Systems~UPSWM">UPSWM</a> - tower mounting kit)
Primary Form Factor Tower
Primary UPS Depth (mm) 229
Primary UPS Height (mm) 325
Primary UPS Width (mm) 191
Shipping Dimensions (hwd / in.) 18.50 x 12.20 x 13.38
3 / 5
Shipping Weight (kg) 20.59
UPS Housing Material PVC
UPS Power Module Dimensions
(hwd, in.)
UPS Power Module Weight (kg) 19.10
UPS Power Module Weight (lbs.) 42.1
ENVIRONMENTAL
Operating Temperature Range +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity 0 to 95%, non-condensing
AC Mode BTU / Hr. (Full Load) 208.6
Battery Mode BTU / Hr. (Full Load) 189.1
COMMUNICATIONS
Communications Interface USB; DB9 Serial
LINE / BATTERY TRANSFER
Transfer Time 5 milliseconds
Low Voltage Transfer to Battery
Power (Setpoint)
12.8 x 7.5 x 9
155
High Voltage Transfer to Battery
Power (Setpoint)
SPECIAL FEATURES
Grounding Lug Equipotential connection (back panel grounding lug)
Cold Start (Startup in Battery Mode
During a Power Failure)
STANDARDS & COMPLIANCE
UPS Certifications CE; Tested to UL60601-1 (medical grade)
WARRANTY
Product Warranty Period
(International)
Product Warranty Period (Mexico) 5-year limited warranty
Product Warranty Period (Puerto
Rico)
274
Cold-start operation supported
5-year limited warranty
5-year limited warranty
© 2020 Tripp Lite. All rights reserved. All product and company names are trademarks or registered trademarks of their respective holders. Use of them does
not imply any affiliation with or endorsement by them. Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
Tripp Lite uses primary and third-party agencies to test its products for compliance with standards. See a list of Tripp Lite's testing agencies:
4 / 5
https:// products/product-certification-agencies
5 / 5
Loading...