Tripp Lite PDU6K User Manual

Owner’s Manual

PDU6K Power Distribution Unit (PDU)

for select UPS Systems

Designed for 2U rack and other mounting options

IMPORTANT SAFETY INSTRUCTIONS. This manual contains information
concerning the proper installation and use of Tripp Lite’s Power Distribution
Units (PDUs). SAVE THESE INSTRUCTIONS.

Note: This PDU is intended only for use with select Tripp Lite UPS Systems.

Do not connect your PDU to an ungrounded outlet. Do not use it with extension cords or
adapters that eliminate its connection to ground. Your PDU is designed for indoor use
only. Install it away from heat emitting devices such as radiators and heat registers. Do
not install where excessive moisture or other conductive contaminants are present. Never
install electrical wiring during a lightning storm.

CAUTION! Outlets are divided into 240V AC and 120V AC types. A total load of 24 amps
can be drawn from the PDU6K. Do not exceed this current rating when connecting
equipment to the PDU6K. If you have any questions, call Tripp Lite Customer Support at
[phone].

Congratulations! Your PDU6K power distribution unit will add a wide range of electrical outlets to select
Tripp Lite SmartOnline UPS Systems and SmartPro UPS Systems. The PDU6K is equipped with a NEMA
L14-30P plug that should only be connected to the NEMA L-14-30R receptacle on the rear of your UPS.

A variety of installation options are available for the
PDU6K including 2U rackmount, wall, under­console and more. Put four rackmount screws
through star washers and the unit’s mounting clip as
shown (A) and attach to end panel using the pre­drilled holes.

Note: The user must determine the fitness of and supply rackmount
screws, bolts or cage nuts required to hold the unit in place before
installation on the desired surface.

Installation

A

2U Recessed Rack Mounting (shown here) allows space for cables.

200306150 PDU6K Owner’s Manual.qxd 7/7/2003 3:00 PM Page 1

Specifications

Series Number: AGACPAM6K
Nominal Voltage/Frequency: 120/240V 50/60Hz
Maximum Load Rating (amps): 24 amps
AC Receptacles: 1xL5-30R, 1xL5-20R, 2xL6-30R, 2xL6-20R, 1x6-20R
AC Line Cord: 4’, w/L14-30 plug
Circuit Breaker (Resettable double pole): 1 × 20 amps
Dimensions (H×W×D, inches): 3.5 × 17.25 × 3.75

Internal Wiring Diagram

(for reference only)

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and
workmanship for its lifetime. If the product should prove defective in material or workmanship within that per iod, Seller will repair or
replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product
(with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping
charges. Call Tripp Lite at [phone] before sending any equipment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR
NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN.
EXCEPT TO THE EXTEND PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL
WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH
ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states
do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights,
and you may have other rights which vary from jurisdiction to jurisdiction).

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe
for the use intended. Since individual applications are subject to great variation, the manufacturer makes no representation
or warranty as to the suitability or fitness of these devices for any specific application.

Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.

Limited Lifetime Warranty

Features

Circuit Breaker

Your PDU6K has a double pole, 20-amp circuit breaker. If the current draw of the 20A
receptacles exceeds 20 amps, the circuit breaker will trip to prevent any possible damage.
When the circuit breaker trips, you must reset the breaker.

Grounding Lug

Use this screw (located on the rear of the unit) to connect your PDU to ground.

200306150 93-2168

200306150 PDU6K Owner’s Manual.qxd 7/7/2003 3:00 PM Page 2