Page 1
Owner’s Manual
Dual Vertical Flat Screen
Desk or Clamp Mount
MODEL: DDR1527SDC
CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR
PROPERTY DAMAGE MAY OCCUR!
75 x 75
100 x 100
Este manual esta disponible en español en la página de Tripp Lite: www.tripplite.com
Ce manuel est disponible en français sur le site Web de Tripp Lite : www.tripplite.com
Русскоязычная версия настоящего руководства представлена на веб-сайте компании
Tripp Lite по адресу: www.tripplite.com
Dieses Handbuch ist in deutscher Sprache auf der Tripp Lite-Website verfügbar: www.tripplite.com
27”
MAX
8 kg (x2)
(17.6 lb.) (x2)
MAX
PROTECT YOUR INVESTMENT!
Register your product for quicker service
and ultimate peace of mind.
You could also win an ISOBAR6ULTRA
surge protector—a $100 value!
www.tripplite.com/warranty
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2015 Tripp Lite. All rights reserved.
1
15-10-034-9334E7-EN.indd 1 10/22/2015 1:34:26 PM
Page 2
NOTE: Read the entire instruction manual before you start installation and assembly.
WARNING
• Do not begin the installation until you have read and understood the instructions
and warnings contained in this manual. If you have any questions regarding any
of the instructions or warnings, please visit www.tripplite.com/support.
• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
•
This product should only be installed by someone of good mechanical ability,
basic building experience and a full understanding of this instruction manual.
• Make sure that the mounting surface can safely support the combined load of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
• Tighten screws firmly, but do not over-tighten. Over-tightening can damage the
items, greatly reducing their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
with
Warranty and Product Registration
5-Year Limited Warranty
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects
in material and workmanship for a period of 5 years from the date of initial purchase. If the product should
prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole
discretion.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE,
ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY
SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES,
INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY
PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL
DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not
allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions
may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from
jurisdiction to jurisdiction).
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate
or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes
no representation or warranty as to the suitability or fitness of these devices for any specific application.
PRODUCT REGISTRATION
Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a
drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
2
15-10-034-9334E7-EN.indd 2 10/22/2015 1:34:27 PM
Page 3
Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to
installing. If any parts are missing or faulty, visit www.tripplite.com/support for service.
Cable Clamp (x2)
3 mm Hex Key (x1)
Clamp (x1)
Pole (x1)
M4X12 (x8)
Mount Assembly with
VESA Plate (x2)
Base (x1)
M4X30 (x8)
Locating Ring (x2)
Top Cap (x1)
M6X15 (x3)
4 mm Hex Key (x1)
5 mm Hex Key (x1)
Spacer (x8)
3
15-10-034-9334E7-EN.indd 3 10/22/2015 1:34:27 PM
Page 4
1a. Desk Clamp Mounting
M6X15
4 mm Hex Key
• Determine approximate location for mount,
keeping in mind display size, height
adjustment and pitch/roll requirements.
• Slip the desk mount assembly over the edge
of desk so that clamp fully contacts desk
edge.
• Turn the knob to adjust the clamp to edge of
desk and secure it tightly.
• If desk edge size slightly exceeds the max
desktop distance, remove the clamp screw
and clamp adjustment plate and reattach the
clamp-adjustment plate upside-down.
1b. Desktop Mounting
Loosen
Tighten
M6X15
4 mm Hex Key
4
15-10-034-9334E7-EN.indd 4 10/22/2015 1:34:28 PM
Page 5
2. Installing the Locating Ring
Tighten
3. Attaching VESA Plate to Display
Slide Locating Ring to desired
position and tighten.
or
M4X12 M4X30 Spacer
Lift the display and align the rear mounting holes with the mount assembly’s VESA plate.
Attach the display to the VESA plate with the appropriate included screws.
Do not over-tighten screws.
5
15-10-034-9334E7-EN.indd 5 10/22/2015 1:34:29 PM
Page 6
4. Installing the Display
Repeat Steps 2 and 3 to install the
second display. When completed,
insert the Top Cap on the top of the
Pole.
Using an assistant or mechanical
lifting equipment, lift the display with
attached Mount Assembly and slide it
down onto the pole until it touches the
Locating Ring. Make sure the display
is safely secured before releasing.
WARNING: Always ensure both monitors face forward. Turning the monitors to face backward
may cause the unit to tip over.
6
15-10-034-9334E7-EN.indd 6 10/22/2015 1:34:29 PM
Page 7
5. Tension Adjustment
3 mm
Hex Key
5 mm Hex Key
Use the appropriate Hex Keys to adjust the swivel. Turn clockwise to increase tension or counter-clockwise to
reduce tension.
6. Cable Management
Use the included Cable Clamps to secure
and organize the cables to the Pole.
7
15-10-034-9334E7-EN.indd 7 10/22/2015 1:34:30 PM
Page 8
7. Adjustment
360°
20°
360°
20°
23.6”
(600 mm)
20°
360°
20°
To adjust the desired location or tilt, use the appropriate Hex Key to adjust. Turn clockwise to tighten or counterclockwise to loosen.
Maintenance
• Check that the bracket is secure and safe to use at regular intervals (at least every three months).
• Please visit www.tripplite.com/support if you have any questions.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
8
15-10-034-9334E7-EN.indd 8 10/22/2015 1:34:37 PM
15-10-034 93-34E7RevA
Loading...