Tripp Lite B011-000 User Manual

help
93-1896
stop again
props
front
open
find
F1 F2
e
sc
!
~
1
t
ab
undo
caps lock
copy
shift s
paste
cut
control
F3
undo
copy
cut
@
#
23456
QWE RTY U
ASDFGHJ
XC
Z
alt
$
F5
F7
F6
F4
%
^
F8
&* ( )
7890
I
KL
B
NM
V
SUN Keyboard
F1 F2
1
234
F3
F5
F7
F6
F4
F8
Win Keyboard
RCtrl F1 RCtrl F2 RCtrl F3 RCtrl F4 RCtrl F5 RCtrl F6 RCtrl F7 RCtrl F8 RCtrl F9 RCtrl F10 RCtrl 1 RCtrl 2 RCtrl 3 RCtrl 4 RCtrl H RWIN LWIN WIN CMD RALT
page up
page down
numlk clear
78
4
1
0
=
/
*
9
-
5
6
+
2
3
.
enter
F9
F10 F11
F12 F13 F14 F15
_
+
-
P
.
F9
[]
: ;
?><
/
com­pose
F10
=
" ’
O
,
ins
back
help home
space
del.
}{
|
end
÷
\
enter
hift
alt graph
Sun Keyboard
Stop Again Props Undo Front Copy Open Paste Find Cut
-
+
Help Right Left Compose Alt Grapher
Tripp Lite World Headquarters 1111 W. 35th Street, Chicago, IL 60609 USA (773) 869-1234, www.tripplite.com
User’s Manual
Console Converter
For SUN
H
Ctrl Ctrl
Alt
Alt graph
PS/2 104 Key Keyboard Emulation Keys
PREVENTING RADIO & TV INTERFERENCE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna; increase the separation between the equipment and receiver; connect the equipment into an outlet on a circuit different from that which the receiver is connected; consult the dealer or an experienced radio/television technician for help. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
com­pose
The PS/2 104 key keyboard can emulate the functions of the SUN keyboard when the Right Control key (RCtrl) is used in conjunction with the keys highlighted in the diagram at the left. The corresponding functions are shown in the table above.
1-YEAR LIMITED WARRANTY
TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products. To obtain service under this warranty, you must obtain a Returned Material Authorization (RMA) number from TRIPP LITE or an aut horize d TRI PP LITE service center. Products must be returned to TRIPP LITE or an a u t h o rize d TRI P P L I TE service center with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase. This warranty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been altered or modified in any way.
EXCEPT AS PROVIDED HEREIN, 1TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied warrantie s; t h ere f o re , t h e a f o re sa id limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL 1TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. S pecif ica lly, TRI P P LITE is not lia ble f o r any co st s, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substit u t es, cla ims by t hird part ie s, or otherwise .
The policy of TRIPP LITE is one of continuous improvement. Specifications are subject to change without notice.
PAPE-1111-101
Model #: B011-000
NOTE: Follow these installation and operating procedures to ensure correct performance and to prevent damage to this unit or to its connected devices.
Copyright © 2001 Tripp Lite. All rights reserved. All trademarks are the property of their respective owners. Technical specifications are subject to change without notice.
- 5 -- 4 -
Overview
The B011-000 PS/2 to SUN interface converter allows you to control a SUN workstation from a PS/2 keyboard, PS/2 mouse and PC monitor by translating their signals to SUN keyboard, mouse, and monitor signals. In addition, the B011-000 fully sup­ports Tripp Lites existing KVM switches, so you can use them to easily integrate SUN workstations into your KVM network.
2. Plug the cable from your PC monitor into the HD15 connector on the Console side of the B011-000.
3. Use a 13W3 male-to-male cable to connect the SUN workstations Video Out port to the B011-000s Video In port.
4. Use an MD8 male-to-male and PIN to PIN cable to connect the SUN workstation’s keyboard and mouse port to the B011-000s keyboard and mouse port.
Screen Saver Time Out SW4 SW5 SW6
5 Minutes OFF ON ON 10 Minutes OFF OFF ON 20 Minutes OFF ON OFF 30 Minutes OFF OFF OFF
Monitor Always ON ON X X
KVM Switch
B011-000B010-000
MAC
PC
SUN Station
Features
M Hot Plug Support for PS/2 Keyboard and Mouse M DIP Switch Selectable Display Resolution M DIP Switch Selectable Screen Saver M DIP Switch Selectable Mouse Speed M No Power Adapter Necessary
Installation
1. Plug the cables from your PS/2 keyboard and PS/2 mouse into the mini-DIN 6 pin connectors on the Console side of the B011-000.
Note: 1. The mouse used with a SUN workstation is a three
button mouse. Use a three button PS/2 mouse to fully emulate its functions.
2. If connecting to a KVM switch, use a PS/2 KVM cable kit to connect the B011-000 to your switch.
MD8
SUN Station
13W3
LEDs
B011-000
DIP SW
DIP Switch Settings
Select the video resolution, the amount of idle time before the screen saver comes on, and the mouse speed with the DIP switch as follows:
Video Resolution SW1 SW2 SW3
1152 x 900 (76Hz) ON OFF OFF 1152 x 900 (76Hz) ON ON OFF
1152 x 900 (66Hz) OFF OFF ON 1280 x 1024 (76Hz) ON OFF ON 1600 x 1280 (76Hz) OFF ON ON
Mouse Speed SW7
High ON
Normal OFF
LEDs
There are three LEDs to indicate operating status: M The ACTIVE LED indicates that PS/2 keyboard or mouse
data is being transmitted.
M The EXTEND LED indicates that the Right Control key (RCtrl)
is active.
M The COMPOSE LED indicates that the Compose key is latched.
Specifications
Function Specification
Power Consumption 50mA (max) Connectors Video In 13W3 Female
Video Out HD15 Female Sun KB & Mouse Mini DIN 8 Pin Female PS/2 KB Mini DIN 6 Pin Female PS/2 Mouse Mini DIN 6 Pin Female
LEDs Active Green
Extend Yellow
Compose Yellow DIP Switch 8 bits Operating Temperature 5 ~ 40o C Storage Temperature -20 ~ 60o C Humidity 0 ~ 80% (RH) Housing Plastic Weight 150g Dimensions (L x W x H) 100 x 80 x 36 mm
- 2 -- 1 - - 3 -
Loading...