Page 1
Quick Installation Guide
TU2-ET100
Page 2
Table of Contents
Table of Contents
Deutsch .....................................................................................................
1. Bevor Sie anfangen ...........................................................................
2. ...................................................................................Installation ......
Troubleshooting ........................................................................................
1
1
2
6
Version 08.30.2006
Page 3
1. Bevor Sie anfangen
Systemanforderungen
CD-ROM-Laufwerk
Prozessor: Intel Pentium 300 MHz oder schneller
Speicher: 256 MB oder mehr
Computer mit freiem USB-1.1- oder -2.0-Port
Windows XP/2000/ME/98SE, Mac OS X
Anwendung
Packungsinhalt
U2-ET100
T
Anleitung zur Schnellinstallation
Treiber CD
Internet
Cable/DSL Modem
Cable/DSL 4-Port
Broadband Router
(TW100-S4W1CA)
Workstation
USB 2.0 to 10/100Mbps
Fast Ethernet Adapter
(TU2-ET100)
Notebook
1
Deutsch
Page 4
2. Installation
1. Legen Sie die Treiber-CD in Ihr
CD-ROM-Laufwerk ein.
2. Verbinden Sie den Adapter mit
einem freien USB-Port Ihres
Computers. Daraufhin erscheint
der Found New Hardware Wizard
(der Assistent „Neue
Hardwarekomponente gefunden“).
Windows XP
3. Markieren Sie No
(Nein) und klicken Sie
dann auf Next (Weiter).
Windows 2000
3. Klicken Sie auf Next
(Weiter).
2
Deutsch
Page 5
Windows XP
Windows 2000
4. Markieren Sie Install
the software
automatically
(Software automatisch
installieren) und
klicken Sie auf Next
(Weiter).
5. Klicken Sie auf
Continue Anyway
(Vorgang dennoch
fortsetzen).
Deutsch
4. Markieren Sie Search
for a suitable driver
for my device
(recommended) (Nach
einem passenden
Treiber für mein Gerät
suchen (empfohlen))
und klicken Sie dann
auf Next (Weiter).
5. Klicken Sie auf
CD-ROM drive
(CD-ROM-Laufwerk)
und anschließend auf
Next (Weiter).
2
Page 6
Windows XP Windows 2000
6. Klicken Sie auf Finish
(Fertigstellen).
7. Gehen Sie zu
Schritt 9.
6. Klicken Sie auf Next
(Weiter).
7. Klicken Sie auf Yes
(Ja).
8. Klicken Sie auf Finish
(Fertigstellen).
4
Deutsch
Page 7
9. Verbinden Sie den Adapter über
ein RJ-45-Kabel mit einem
Umschalter, Router oder
Kabel/DSL-Modem.
Ihre Installation ist beendet!
5
Deutsch
Page 8
Troubleshooting
Can I connect or disconnect TU2-ET100 while the computer is on?
Q1:
Yes, you can connect or disconnect TU2-ET100 while the computer is on
A1:
because the USB interface is Plug-and-Play compliant and hot-pluggable.
Windows is unable to recognize my hardware. What should I do?
Q2:
First, make sure your computer meets the minimum requirements as specified
A2:
in Section 1 of this Quick Installation Guide. Second, try plugging the adapter into
a different USB port.
Windows recognizes my new hardware, but I'm unable to connect to my
Q3:
network. What should I do?
First, verify that the network cable is securely connected from your switch or
A3:
router to your adapter. Second, verify that the LEDs on your adapter are lit. Third,
verify that the TCP/IP settings are set to Obtain an IP address automatically.
How do I install this device on Windows 98SE and ME?
Q4:
Refer to the User Guide included on the Driver CD-ROM for installation
A4:
instructions.
If you still encounter problems or have any questions regarding the TU2-ET100, please
refer to the User's Guide included on the Driver CD-ROM or contact TRENDnet's
Technical Support Department.
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
6
Page 9
TRENDnet Technical Support
.
US Canada
Toll Free Telephone: 1(866) 845-3673
24/7 Tech Support
Europe (Germany France Italy Spain Switzerland UK)
Toll Free Telephone: +00800 60 76 76 67
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
. . . . .
Worldwide
Telephone: +(31) (0) 20 504 05 35
English/Espanol - 24/7
Francais/Deutsch - 11am-8pm, Monday - Friday MET
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com
3135 Kashiwa Street
Torrance, CA 90505
USA
Copyright ©2006. All Rights Reserved. TRENDnet.
Loading...