TRENDnet TPL-410AP Quick Install Guide
Powerline 500 AV Wireless Access Point
TPL-410AP
Quick Installation Guide (1)
TPL-410AP (V1) /12.17.2013
Before You Start
Package Contents
TPL-410AP
CD-ROM (Utility and User's Guide)
Multi-Language Quick Installation Guide
Network cable (1.8 m / 6 ft.)
Installation Requirements
Existing network with internet access
Additional HomePlug AV or IEEE 1901 compliant powerline adapter
Two powerline adapters are required to create a powerline network
®
1
2. Connect Powerline Adapters
Internet
Important Note:
TRENDnet powerline adapters connect automatically out of the box. No additional Powerline
installation steps are necessary. To change the default Powerline encryption key (recommended) or
connect the adapters to an existing network that is using a different encryption key, please follow
the sync button procedure below.
If you are connecting the adapters to a non-TRENDnet Powerline device, please refer to the
manufacturer's documentation for the appropriate sync button procedure.
It is recommended to plug the adapters into nearby outlets before installing the devices to the
desired locations.
1
Router
Push Sync button
for 3 seconds,
then release.
PWR (Power)
LED will blink.
Powerline adapter
(not included)
PL (Power
Line) LED
3
will turn
solid when
connected.
(may take
over one
minute).
2
2
TPL-410AP
Push Sync button
for 3 seconds,
then release. PL
(Power Line) LED
will blink.
PL (Power
Line) LED
3
will turn
solid when
connected.
(may take
over one
minute).
Loading...