TRENDNET TEW703PI PIL Users Manual
WOTW Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at
the factory to match the intended destination. The firmware setting is not accessible by the end user.
For Taiwan 警語：
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之
特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方
得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫
療用電波輻射性電機設備之干擾。
1
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been
applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC:
EN60950-1: 2010
Safety of Information Technology Equipment
EN 62311: 2008
Assessment of electronic and electrical equipment related to human exposure restrictions for electromagnetic fields (0 Hz – 300GHz)
EN 300 328 V1.7.1 (2006-10)
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband transmission systems; Data transmission equipment
operating in the 2,4 GHz ISM band and using wide band modulation techniques; Harmonized EN covering essential requirements
under article 3.2 of the R&TTE Directive
EN 301 489-1 V1.8.1 (2008-04)
Electromagnetic compatibility and Radio Spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio
equipment and services; Part 1: Common technical requirements
EN 301 489-17 V2.1.1 (2009-05)
Electromagnetic compatibility and Radio spectrum Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio
equipment and services; Part 17: Specific conditions for 2,4 GHz wideband transmission systems and 5 GHz high performance RLAN
equipment
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member states and EFTA countries,
except in France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device
for setting up outdoor radio links and/or for supplying public access to telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10
mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the national spectrum
authority in France.
[Czech]
[Danish]
[German]
[Estonian]
Deutsch
English
Česky
Dansk
Eesti
TRENDnet tímto prohlašuje, že tento TEW-703PI/TEW-703PIL je ve shodě se základními požadavky a
dalšími příslušnými ustanoveními směrnice 1999/5/ES.
Undertegnede TRENDnet erklærer herved, at følgende udstyr TEW-703PI/TEW-703PIL overholder de
væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
Hiermit erklärt TRENDnet, dass sich das Gerät TEW-703PI/TEW-703PIL in Übereinstimmung mit den
grundlegenden Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 1999/5/EG
befindet.
Käesolevaga kinnitab TRENDnet seadme TEW-703PI/TEW-703PIL vastavust direktiivi 1999/5/EÜ
põhinõuetele ja nimetatud direktiivist tulenevatele teistele asjakohastele sätetele.
Hereby, TRENDnet, declares that this TEW-703PI/TEW-703PIL is in compliance with the essential
iii
requirements and other relevant provisions of Directive 1999/5/EC.
Español
[Spanish]
Ελληνική
[Greek]
Français
[French]
Italiano
[Italian]
Latviski
[Latvian]
Lietuvių
[Lithuanian]
Nederlands
[Dutch]
Malti
[Maltese]
Magyar
[Hungarian]
Por medio de la presente TRENDnet declara que el TEW-703PI/TEW-703PIL cumple con los requisitos
esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE.
ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ TRENDnet ∆ΗΛΩΝΕΙ ΟΤΙ TEW-703PI/TEW-703PIL ΣΥΜΜΟΡΦΩΝΕΤΑΙ
ΠΡΟΣ ΤΙΣ ΟΥΣΙΩ∆ΕΙΣ ΑΠΑΙΤΗΣΕΙΣ ΚΑΙ ΤΙΣ ΛΟΙΠΕΣ ΣΧΕΤΙΚΕΣ ∆ΙΑΤΑΞΕΙΣ ΤΗΣ Ο∆ΗΓΙΑΣ
1999/5/ΕΚ.
Par la présente TRENDnet déclare que l'appareil TEW-703PI/TEW-703PIL est conforme aux exigences
essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE.
Con la presente TRENDnet dichiara che questo TEW-703PI/TEW-703PIL è conforme ai requisiti
essenziali ed alle altre disposizioni pertinenti stabilite dalla direttiva 1999/5/CE.
Ar šo TRENDnet deklarē, ka TEW-703PI/TEW-703PIL atbilst Direktīvas 1999/5/EK būtiskajām prasībām
un citiem ar to saistītajiem noteikumiem.
Šiuo TRENDnet deklaruoja, kad šis TEW-703PI/TEW-703PIL] atitinka esminius reikalavimus ir kitas
1999/5/EB Direktyvos nuostatas.
Hierbij verklaart TRENDnet dat het toestel TEW-703PI/TEW-703PIL in overeenstemming is met de
essentiële eisen en de andere relevante bepalingen van richtlijn 1999/5/EG.
Hawnhekk, TRENDnet, jiddikjara li dan TEW-703PI/TEW-703PIL jikkonforma mal-ħtiġijiet essenzjali u
ma provvedimenti oħrajn relevanti li hemm fid-Dirrettiva 1999/5/EC.
Alulírott, TRENDnet nyilatkozom, hogy a TEW-703PI/TEW-703PIL megfelel a vonatkozó alapvetõ
követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak.
Polski
[Polish]
Português
[Portuguese]
Slovensko
[Slovenian]
Slovensky
[Slovak]
Suomi
[Finnish]
Svenska
[Swedish]
Niniejszym TRENDnet oświadcza, że TEW-703PI/TEW-703PIL jest zgodny z zasadniczymi wymogami
oraz pozostałymi stosownymi postanowieniami Dyrektywy 1999/5/EC.
TRENDnet declara que este TEW-703PI/TEW-703PIL está conforme com os requisitos essenciais e outras
disposições da Directiva 1999/5/CE.
TRENDnet izjavlja, da je ta TEW-703PI/TEW-703PIL v skladu z bistvenimi zahtevami in ostalimi
relevantnimi določili direktive 1999/5/ES.
TRENDnet týmto vyhlasuje, že TEW-703PI/TEW-703PIL spĺňa základné požiadavky a všetky príslušné
ustanovenia Smernice 1999/5/ES.
TRENDnet vakuuttaa täten että TEW-703PI/TEW-703PIL tyyppinen laite on direktiivin 1999/5/EY
oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen.
Härmed intygar TRENDnet att denna TEW-703PI/TEW-703PIL står I överensstämmelse med de
väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 1999/5/EG.
iv
TABLE OF CONTENTS
Introduction ...............................................................................................1
Overview of this User’s Guide ............................................................................... 1
Unpacking and Setup .................................................................................2
Unpacking ............................................................................................................. 2
Setup ..................................................................................................................... 2
IDentifying external components...............................................................3
LED ........................................................................................................................ 3
Check the Installation............................................................................................ 3
Software Installation ..................................................................................4
Windows Based Utility Installation........................................................................ 4
Wireless Utility Setting...............................................................................6
General.................................................................................................................. 6
Profile.................................................................................................................... 7
Available Networks ............................................................................................. 10
Status .................................................................................................................. 11
Statistics .............................................................................................................. 13
WPS..................................................................................................................... 14
v
INTRODUCTION
Congratulations on your purchase of TEW-703PI / TEW-703PIL Wireless N PCI
Adapter.
This manual contains detailed instructions regarding the operation of this product.
Please keep this manual for future reference.
With the TEW-703PI / TEW-703PIL Wireless N PCI Adapter, a desktop or laptop
computer can communicate with another computer wirelessly. An easy-to-use
utility is bundled with the TEW-703PI / TEW-703PIL Wireless N PCI Adapter for
configuration, monitoring, and diagnostic purposes.
The Wireless N PCI Adapter can provide wireless speeds up to 150Mbps.
The Wireless N PCI Adapter provides users with access to real-time information
anywhere in their organization. The mobility of the Wireless N PCI Adapter
provides increased productivity and service, which are normally restricted under
wired networks. The TEW-703PI / TEW-703PIL Wireless N PCI Adapter can fit into a
wide range of niches from peer-to-peer networks, suitable for a small number of
users, to full infrastructure networks of thousands of users while still allowing
roaming in a broad area.
Overview of this User’s Guide
Introduction. Describes the Wireless N PCI Adapter and its features.
Unpacking and Setup. Helps you get started with the basic installation of the
Wireless N PCI Adapter.
Hardware Installation. Describes the LED indicator on the adapter.
Software Installation. Describes how to setup the driver and utility settings.
Technical Specifications. Lists the technical (general, physical and environmental)
specifications of the TEW-703PI / TEW-703PIL Wireless N PCI Adapter.
1
UNPACKING AND SETUP
This section provides unpacking and setup information for the TEW-703PI or TEW703PIL Wireless N PCI Adapter.
Unpacking
The box should contain the following items:
TEW-703PI or TEW-703PIL Adapter
CD-ROM (Utility/Driver & User's Guide)
Multi-Language Quick Installation Guide
If any item is found missing or damaged, please contact your local reseller for
replacement.
Setup
Before installation, check the following:
Make sure your computer is running at least a 300MHz or above processor
with 256MB RAM or above.
Visually inspect the PCI Adapter and make sure that it is fully plugged in to the
PCI slot.
The operating system on your computer must be the following: Windows 7,
Vista or XP (32/64-bit).
One 802.11n or 802.11b/g access point or router.
Make sure the environment has minimal interference and obstructions.
2
IDENTIFYING EXTERNAL COMPONENTS
LED
Link
A green Link LED indicator lights up when the TEW-703PI / TEW-703PIL Wireless N
PCI Adapter is connected to a wireless network successfully.
ACT (Activity)
The ACT LED indicator blinks green when the 802.11n Wireless LAN Adapter is
transmitting or receiving data.
Check the Installation
Make sure that the LEDs of the Wireless N PCI Adapter are clearly visible and that
the status of the network link can be seen instantly:
1. Once the device is plugged into the station’s PCI slot, the LED of the Wireless
LAN Adapter will light up indicating a normal status.
2. After the device is plugged into the station’s PCI slot and the driver is installed,
the Link will start blinking, signifying that the device is starting to scan for
wireless devices near the Wireless LAN Adapter.
3. If the Wireless LAN Adapter is linked up and transmitting data properly to the
selected access point or to another Wireless LAN station, the ACT LED’s green
light will display.
3
SOFTWARE INSTALLATION
This section describes how to install the driver and utility for the TEW-703PI /
TEW-703PIL Wireless N PCI Adapter.
Windows Based Utility Installation
1) Insert the Utility and Driver CD-ROM into your computer’s CD-ROM Drive and
then clicks Install Utility.
2) Follow the InstallShield Wizard Instructions.
4
Loading...