Quick Installation Guide
TEW-653AP
1.01
Table of Contents
English 1
1. Before You Start
2. Hardware Installation 2
3. Power-over-Ethnernet Installation 3
4. Configure the Access Point 5
5. Mounting 8
Troubleshooting 9
1
Version 11.16.2009
1. Before You Start
Package Contents
?
TEW-653AP
ENGLISHFRANÇAISDEUTSCHESPAÑOL
System Requirements
?Web Browser: Internet Explorer (6.0 or higher)
?A computer with a network adapter properly installed.
?A network Switch or Hub with an available network LAN port.
?Power over Ethernet (PoE) Switch (e.g. TPE-80WS) (Optional)
?Injector (e.g TPE-111GI ) (Optional)
Note:
The TEW-653AP only works with Power over Ethernet (PoE) devices that follow the
IEEE 802.3af standard.
?Multi-Language Quick Installation Guide
?CD-ROM User’s Guide
?Cat. 5 Ethernet Cable (1m / 3.3ft.)
?Power Adapter (12V DC, 1A)
?Mounting Kit
( )
РУССКИЙ
1
2. Hardware Installation
Note: Locate an optimum location for the Access Point. The best place for the Access
Point is usually at the center of your wireless network. Please connect the computer
configuring the TEW-653AP to the same switch/hub.
1. Run a RJ-45 cable and the power adapter
through the cable clip on the TEW-653AP.
2. Connect the RJ-45 cable from the Switch/Hub
to the LAN port on the Access Point.
3. Connect the Power Adapter to the Access Point
and then to a power outlet.
4. Verify that the wireless, LAN and power LEDs
are on.
ENGLISHFRANÇAISDEUTSCHESPAÑOL
РУССКИЙ
2
3. Power-over-Ethernet Installation
Using the TEW-653AP with a PoE switch
ENGLISHFRANÇAISDEUTSCHESPAÑOL
1. Connect a RJ-45 cable from the Power-OverEthernet Switch (e.g. TRENDnet TPE-80WS) to
the LAN port on the Access Point.
2. Verify that the wireless, LAN and power LEDs
are on. Please refer to step 4 in the Hardware
Installation section.
РУССКИЙ
3
Using the TEW-653AP with the TPE-111GI
1. Connect the Power Cord to the Power
Adapter.
2. Connect the Power Adapter to the DC 48V IN
connector on the TPE-111GI. Then connect
the Power Cord to an outlet.
3. Connect a CAT-5 cable from a switch to the
TPE-111GI's DATA IN port.
4. Connect a CAT-5 cable from the TEW-653AP's
LAN port to the TPE-111GI's PoE Out port.
ENGLISHFRANÇAISDEUTSCHESPAÑOL
5. Verify that the wireless, LAN and power LEDs
are on. Please refer to step 4 in the Hardware
Installation section.
РУССКИЙ
4
Loading...