TRENDNET TEW455APBO Users Manual
Status Firmware Upgrade
This page allows you to update the firmware (software) in the AP. New firmware are issued to improve the
performance and add features to the product.
The new firmware will be name “apimg1”.
1. Save the file in your PC.
2. Browse to the file with the name “apimg1”.
3. Click on Upload.
4. Reboot the AP and the process is complete.
5. After reboot perform a default factory setting.
Do not change the filename of the new firmware. New firmware with filename other than “apimg1” will cause the
process to fail.
Status Firmware Version
This page presents information of the firmware version of the AP.
Pg 22 of 30
7 OUTDOOR APUTILITY INSTALLATION
WAN/Intern
et
QS PC
AP
Wireless Client
Introduction
The Outdoor AP utility is an easy-to-use software that allows an Administrator to quickly configure the AP at first
boot-up. The QS Utility only communicates with authorized Access Points and Bridge. The Utility allows the devices
to be monitored and configured even if they all have the same default IP Address at first boot-up after installation.
PC Requirement
X86 based CPU, 600Mhz & above
128 MB RAM
1.5 MB hard disk space
Ethernet port / Wireless LAN adapter
Windows 2000 and above
Pg 23 of 30
Installation
Step one
Double click on the file setup.exe and click Next to continue.
Step two
Click Next to accept the default installation directory. If you wish to change the installation directory, click on the
Change button to select a new directory.
Pg 24 of 30
Loading...