?Cabo de rede Cat-5e ou Cat-6
?Superfície deve suportar no mínimo 245g
?A tomada elétrica deve estar a no máximo 1,82 metros (6 feet) do Switch.
?Assegure-se de que o cabo de alimentação está adequadamente conectado.
?Assegure-se de que há ventilação adequada e dissipação de calor aproriada no
entorno do Switch
?Não coloque objetos pesados sobre o Switch
?Guia de Instalação Rápida Multilínguas
?Adaptador de Tensão Externo (5V DC, 1A)
1
2. Instalação de Hardware
1.
Conecte o adaptador de Alimentação ao
TEG-S8g e então a uma tomada elétrica.
2. Conecte um cabo de rede RJ-45 Cat.5e ou
Cat.6 do computador a uma porta Ethernet
diisponível no TEG-S8g.
PORTUGUÊS
2
3. LEDs
Power
Verde: Ligado.
Não Iluminado: Desligado.
Português
Link/ACT
Verde (Estático):
Conectado a outro dispositivo.
Verde (Piscando):
Link em atividade.
Não Iluminado:
Nada é detectado na porta.
Velocidade
Verde: A conexão da porta é 2000 (Full).
Ambar:
A conexão da porta é 100/200 (Half/Full).
Não Iluminado:
A conexão da porta é 10/20 (Full/Half) ou nada é
detectado na porta.
3
Especificações Técnicas
Hardware
Standards
Network Media
Data Rate
Protocol / Topology
Power Consumption
Switch Fabric
Interface8 x 10/100/1000Mbps Auto-MDIX RJ-45 ports
Data RAM Buffer
Filtering Table
Jumbo Frame Support
Diagnostic LEDs
Power Adapter
Dimension
Weight
Temperature
Humidity
Certification
?IEEE 802.3 10Base-T
?IEEE 802.3u 100Base-TX
?IEEE 802.3ab 1000Base-T
?IEEE 802.3x Flow Control
?IEEE 802.3az (draft 2.0) Energy Efficient Ethernet
?Ethernet: Cat. 3, 4, 5, up to 100m
?Fast Ethernet: Cat. 5 up to 100m
?Gigabit Ethernet: Cat. 5, 5e, 6, up to 100m
165 x 102 x 28mm (6.5 x 4 x 1.1 in.)
245g (8.6 oz)
?Operating: 0° ~ 40° C (32° ~ 104° F)
?Storage: -10° ~ 70° C (14° ~ 158° F)
Max. 90% (non-condensing)
FCC, CE
4
Troubleshooting
1. Depois de conectar o Switch a uma tomada elétrica, os LEDs não acendem.
1. Verifique a conexão do cabo de alimentação ao TEG-S8g e à tomada.
2. Verifique se a tomada utilizada está alimentada.
2. Quando eu conecto um computador a uma porta do Switch os LEDs Power e
Link/ACT acendem mas não estou obtendo velocidades Gigabit.
1. V
erifique os LEDs. Se o LED velocidade está verde a velocidade de conexão
do computador é 1000Mbps. Se o LED velocidade está ambar a velocidade de
conexão do computador é 100Mbps. Se o LED velocidade está apagado a
velocidade de conexão do computador é 10 Mbps
2. Verifique os cabos Ethernet. Certifique-se de estar usando os cabos Ethernet
Cat.5e ou Cat.6. Alguns cabos CAT-5 não são compatíveis com Gigabit.
3. Certifique-se de que o adaptador de rede de seu computador é Gigabit
Ethernet.
3. Depois de conectar meus PCs ao Switch, não fui capaz de compartilhar
arquivos.
1. Verifique os LEDs no Switch. Certifique-se de que o LED LINK/ACT está aceso.
2. Verifique o cabo de rede. O comprimento mínimo do cabo é de 1,50 metros e o
comprimento máximo do cabo é de 100 metros.
3. Desabilite qualquer software de firewall.
4. Verifique se está habilitada a função de compartilhamento de arquivo. Favor
entrar em contato com seu provedor de sistema operacional para mais
informações.
4. Após conectar meus PCs ao Switch, eu consigo acessar a Internet apenas por
um computador.
O Switch não é projetado para compartilhar Internet entre vários computadores.
Você precisa de um roteador internet como o TW100-S4W1CA.
5. Onde está localizada a porta uplink do Switch?
Uma vez que todas as portas são Auto-MDIX, qualquer das portas pode ser
utilizada para uplink.
Se você ainda encontrar problemas ou tiver alguma pergunta referente ao TEG-S8g
favor entrar em contato com o Departamento de Suporte Técnico da
Trendnet.
4
Limited Warranty
TRENDnet warrants its products against defects in material and workmanship, under normal
use and service, for the following lengths of time from the date of purchase.
TEG-S8g - 3 Years Limited Warranty
AC/DC Power Adapter, Cooling Fan and Power Supply carry a 1 year limited warranty
If a product does not operate as warranted during the applicable warranty period, TRENDnet
shall reserve the right, at its expense, to repair or replace the defective product or part and
deliver an equivalent product or part to the customer. The repair/replacement unit's warranty
continues from the original date of purchase. All products that are replaced become the
property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet
does not issue refunds or credit. Please contact the point-of-purchase for their return policies.
TRENDnet shall not be responsible for any software, firmware, information, or memory data of
customer contained in, stored on, or integrated with any products returned to TRENDnet
pursuant to any warranty.
There are no user serviceable parts inside the product. Do not remove or attempt to service the
product by any unauthorized service center. This warranty is voided if (i) the product has been
modified or repaired by any unauthorized service center, (ii) the product was subject to accident,
abuse, or improper use (iii) the product was subject to conditions more severe than those
specified in the manual.
Warranty service may be obtained by contacting TRENDnet within the applicable warranty
period and providing a copy of the dated proof of the purchase. Upon proper submission of
required documentation a Return Material Authorization (RMA) number will be issued. An RMA
number is required in order to initiate warranty service support for all TRENDnet products.
Products that are sent to TRENDnet for RMA service must have the RMA number marked on the
outside of return packages and sent to TRENDnet prepaid, insured and packaged appropriately
for safe shipment. Customers shipping from outside of the USA and Canada are responsible for
return shipping fees. Customers shipping from outside of the USA are responsible for custom
charges, including but not limited to, duty, tax, and other fees.
5
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS
WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S
OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE
EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED,
EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
TRENDNET NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME
FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION
MAINTENANCE OR USE OF TRENDNET'S PRODUCTS.
TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND
EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT
EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT,
IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR
MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE INTENDED USE, OR BY
ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO
EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN
CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL,
INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE
OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER
FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION,
MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE
POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR,
REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT TRENDNET'S OPTION.
THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY
REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
Governing Law: This Limited Warranty shall be governed by the laws of the state of California.
Some TRENDnet products include software code written by third party developers. These codes
are subject to the GNU General Public License ("GPL") or GNU Lesser General Public License
("LGPL").
Go to or Download section and look for
the desired TRENDnet product to access to the GPL Code or LGPL Code. These codes are
distributed WITHOUT WARRANTY and are subject to the copyrights of the developers.
TRENDnet does not provide technical support for these codes. Please go to