Trendnet TEG-S2620IS User Manual
Quick Installation Guide
TEG-S2620is
H/W: V1
Table of Contents
Table of Contents
English ......................................................................................................
1. Before You Start
2. Hardware Installation ........................................................................
3. Configure the Switch .........................................................................
Troubleshooting .........................................................................................
................................................................................
1
1
2
3
6
Version 04.04.2009
1. Before You Start
Package Contents
TEG-S2620is
?
?Multi-Language Quick Installation
Guide
?User's Guide CD-ROM
?RS-232 cable
? Power Cord
? Rack Mount Kit
?Rubber Feet
System Requirements
Web Browser: Internet Explorer (6 or 7)
?
?A computer with a network adapter properly installed
?A RJ-45 network cable
Optional Equipment
?
EIA standard 19” rack
?Mini-GBIC module (e.g. TEG-MGBSX, TEG-MGBS10, TEG-MGBS40,
TEG-MGBS80, TEG-MGBS10D35, TEG-MGBS40D35) for Mini-GBIC slots.
Application
Workstation
Workstation with
10/100Mbps PCI Adapter
(TE100-PCIWN)
Workstation with
PCI Adapter
(TEG-PCITXR)
24-Port 10/100Mbps Layer 2 Stackable Switch with
2 shared Gigabit Ports and Mini-GBIC Slots
RS-232
(TEG-S2620is)
1000MbpsFiber 10/100Mbps
1
English
Multi-Mode Fiber
Mini-GBIC Modules
(TEG-MGBSX)
Multi-Mode Fiber
Mini-GBIC Modules
(TEG-MGBSX)
2. Hardware Installation
Note: The Mini-GBIC slots are shared with port 25 and 26 Gigabit Ethernet ports.
When the Mini-GBIC slots are in use, port 25 and 26 Gigabit Ethernet ports are
disabled.
1. Connect the Power Cord to
the TEG-S2620is and then to a
power outlet.
2. Connect a RJ-45 network cable
from the computer to an available
Ethernet port on the TEG-S2620is.
3. Verify that the following panel lights
are on: POWER and LINK/ACT.
2
English
Loading...