TRENDnet N300 TEW-739APBO Quick Installation Manual

Ÿ N300 Outdoor PoE Access Point

TEW-739APBO

TEW-739APBO (V1) /06.19.2014

Ÿ Quick Installation Guide (1)

Ÿ TEW-739APBO
Ÿ CD-ROM (User's Guide)
Ÿ Multi-Language Quick Installation Guide
Ÿ Proprietary PoE injector
Ÿ Power adapter (48 V DC, 0.5 A)
Ÿ Mounting hardware
Ÿ Waterproof RJ-45 plug (network cable is not included)
Ÿ Grounding wire

Package Contents

1. Before You Start

1

Installation Requirements

Ÿ Requires antennas: TEW-AO46S or TEW-AO57

Ÿ Computer with a network port and web browser

Ÿ A network switch or router with an available network LAN port
Ÿ RJ-45 network cables (sold separately)
Ÿ Phillips screwdriver

Note:

Ÿ The TEW-739APBO does not support IEEE 802.3at/af. You must use the proprietary Power

over Ethernet injector that is supplied with the TEW-739APBO.

2

2. Hardware Configuration

Note: The default IP address of the TEW-739APBO is 192.168.10.100. To configure the

TEW-739APBO, your network adapter must have an IP address within the 192.168.10.x subnet
(e.g. 192.168.10.50). Please refer to the Appendix in the User's Guide for more information.

Phase 1: Access Point Setup

Note:

Ÿ The initial configuration should be completed in a testing environment. Configure the device

before mounting.

Included PoE injector

3

5. Connect the other end of a network cable to your computer's Ethernet port.

6. Connect the power adapter into the Power over Ethernet Injector. Then connect the power

adapter into a power outlet. (For EU version, toggle the power switch to the “On” position).

7. Assign a static IP address to your computer's network adapter in the subnet of 192.168.10.x
(e.g. 192.168.10.25) and a subnet mask of 255.255.255.0.

1. Connect the TEW-AO46S or the TEW-AO57 antennas to the TEW-739APBO.

2. Connect one end of a network cable into the TEW-739APBO.

3. Connect the other end of the network cable to the P+DATA OUT port on the Power over

Ethernet Injector.

4. Connect one end of another network cable to the 10/100 DATA IN port on the Power over
Ethernet Injector.

8. Open your web browser, type the IP address of the access point in the address bar, and then
press Enter. The default IP address is 192.168.10.100.

4

9. Enter the User name and Password, and then click OK. By default:
User Name: admin
Password: admin

Note: Username and password are case sensitive.

Note: For first time installation, you are required to change the admin password.

10. Enter a new admin password.

11. Confirm the new password.

12. Click Save.

13. Please wait while the access point reboots.

14. Click Wireless " Virtual AP.

15. Click Edit.

Note: To protect your network from any unauthorized access it is recommended to enable
wireless encryption.

5

16. Select WPA2-PSK for security type.

17. Select AES for cipher suite.

18. Enter a Pre-shared Key (wireless password).

19. Click Save.

16

17

18
19