TRENDnet N300, TEW-638PAP 1.01 User Manual
Quick Installation Guide
TEW-638PAP
1.01
Table of Contents
English 1
1. Before You Start
2. Hardware Installation 2
3. Power-over-Ethernet Installation 8
Troubleshooting 10
1
Version 01.08.2010
1. Before You Start
Package Contents
TEW-638PAP
?
?Multi-Language Quick Installation Guide
?CD-ROM (Utility and User's Guide)
?AC Power Adapter (12V DC, 0.5A)
?Cat. 5 Ethernet Cable (0.6m / 2ft.)
System Requirements
Web Browser: Internet Explorer (6 or higher)
?
?A computer with a network adapter or wireless adapter properly installed
?A router with an available network LAN port
?An available DHCP Server – routers usually have a built-in DHCP server
?Power over Ethernet (PoE) Switch (e.g. TPE-80WS) (Optional)
?Injector (e.g. TPE-111GI) (Optional)
Note: The TEW-638PAP only works with Power over Ethernet (PoE) devices that
follow the IEEE 802.3af standard.
1
2. Hardware Installation
Note:
1. Locate an optimum location for the Access Point. The best place for the Access Point
is usually at the center of your wireless network.
2. Disable any anti-virus and firewall programs before starting hardware installation.
3. For Power-Over-Ethernet installation instructions, please refer to section
3. Power-Over-Etherent installation.
For Windows Users
1. Insert Utility CD-ROM into your computer's
CD-ROM drive.
2. Click Run Setup.exe (Windows 7/Vista only)
3. Click Setup Wizard.
4. Click I accept the terms in the License
Agreement and then click Next.
2
5. Connect the provided RJ-45 cable from a LAN
port on your Router to the LAN port on the
TEW-638PAP. Then click Next.
6. Connect a RJ-45 cable from a LAN port on your
Router to the Ethernet port on your computer.
7. Connect the Power Adapter to the Access Point
and then to a power outlet. Verify that the
power switch is set to the on position. and then
click Next.
8. Select the TEW-638PAP from the list and then
click Configure.
3
9. Enter a password and then click Login. The
default password is admin.
10. Select Access Point and then click Next.
Note: For AP Client setup, please refer to the
User's Guide for step by step instructions.
The User's Guide can be found on this
product's CD-ROM.
11. Select Dynamic IP Address Configuration
and then click Configure.
12. Select Manual setup and then click Next.
4
Loading...