Trendnet EL-HS800 DATA SHEET

Quick Installation Guide

EL-HS800

1. How to Install

1. Rotate the EL-HS800's cover
counter-clockwise to begin cable
installation.

2. Remove the thumbscrew and
protective plating from the goose
neck wall mount.

3. Run all necessary cables (CAT 5
cable, Power Adapter cable, and
the EL-HS800's power terminals)
through the goose neck wall
mount. When using a wireless
camera, please run the Antenna
cable also.

1

English

Version 01.18.2006

4. Run each cable through the
opening located at the top of the
EL-HS800. DO NOT run all cables
through the opening
simultaneously. Serious blockage
can occur.

5. After inserting the appropriate
cables, extend each cable to 6
inches for camera installation.

6. Caution: Before cutting any power
cord, make sure that the power
cord is NOT PLUGGED into an
electrical source. Now take a
power cord with a two-prong plug
and cut the wire.

2

English

7. Use a precision knife or a sharp
object to split the wire in two
halves.

8. Peel the plastic sheath to expose
the copper wiring. It is
recommended that you use a wire
stripper to remove the plastic
sheath effectively.

9. You should have two halves of
exposed copper wire as shown
below.

3

English