Transition Networks A-CF-01(SM), A-CF-01, MEDIA CONVERTER A-CF-01 User Manual

51.38 Kb
Loading...

MEDIA CONVERTER TECHNICAL SPECIFICATIONS

Standards

ATM UNI 3.1 #AF-PHY-0015

Case dimensions

3.9" x 3.0" x 1.0"

(99mm x 76mm x 25mm)

Environment

Temperature:

0-40°C (32° to 104° F )

 

Humidity

10-90%, non condensing

 

Altitude

0-10,000 feet

Warranty

Lifetime

 

Power Supply Requirements Replace power supply with only the equivalent input rating (see below) and output rating (regulated 9VDC at 0.5 A).

TN PN

Requirement

Location

3517

240 volts, 50 hertz

United Kingdom

3516

230 volts, 50 hertz

Europe

3518

120 volts, 60 hertz

USA/Canada/Mexico

3514

100 volts, 50-60 hertz

Japan

3515

240 volts, 50 hertz

Australia

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

Compliance Information

UL Listed

CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Copyright Restrictions

© 1997 TRANSITION Networks.

All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Trademark Notice

Minneapolis, MN 55344 USA

25/155 Mb/s ATM

Copper-to-Fiber Media Converter

A-CF-01, A-CF-01(SM)

USER’S GUIDE

The TRANSITION Networks ATM (Asynchronous Transfer Mode) copper-to- fiber media converters connect twisted-pair copper cable network segments to multimode fiber optic cable network segments (using A-CF-01) OR to singlemode fiber optic cable network segments (using A-CF-01(SM)).

UTP

A-CF-01

Fiber

The ATM media converters provide network connection using an RJ-45 twistedpair ATM connector and a set of RX (receive) and TX (transmit) SC-type ATM fiber connectors. NOTE: Effective cable distances are determined by ambient RF noise and by signal loss in the cable. The fiber connection, with low signal loss and high resistance to radio frequency noise, allows extended distances between ATM devices. Twisted-pair runs are best kept as short as possible to preserve signal integrity.

Status LEDs on the connector side of the media converter provide the following information:

Pwr

(Power) Illuminated

 

 

Activity

 

 

 

 

 

 

 

 

green LED indicates

 

 

Fiber

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

connection to external

 

 

Copper

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AC power.

 

Fiber

 

LinkCopper

 

Activity (Fiber)

Steady green LED

 

 

 

 

 

 

 

 

 

 

indicates the fiber port is active.

 

 

 

 

 

 

 

 

 

Activity (Copper) Steady green LED indicates the twisted-pair port is active.

All registered trademarks and trademarks are the property of their respective owners.

33021.D

+ 1 hidden pages