Transition Networks E-TEL-1200, E-TX-FX-0600, E-TX-FX-1200 User Manual

COMPLIANCE INFORMATION

UL Listed C-UL Listed (Canada) CISPR/EN55022 Class A

FCC Regulations

This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.

Canadian Regulations

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.

Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

European Regulations

Warning

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Achtung !

Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen werantwortlich ist.

Attention !

Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques appropriées

Trademark Notice

All registered trademarks and trademarks are the property of their respective owners.

© 1999 TRANSITION Networks. All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.

Printed in the U.S.A. 33134.B

CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.

Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen einschliesslich der gegenseitigen Anerkennung ihrer Konformität.

The rack-mountable E-TX-FX-1200, E-TEL-1200, and E-TX-FX-0600 series multi-port media converters with

LinkAlert™* allow the network

administrator of a large and complex network to extend the distances between multiple sets of 100BASE-TX and 100BASE-FX devices.

E-TX-FX-1200

(shown) Provides twelve (12) independent media converter

connections between Fast Ethernet

™

over twisted-pair copper (twelve RJ-45

connectors) and Fast Ethernet

™

over singlemode or multimode fiber (twelve

fiber connectors, selected as a set according to network requirements).

E-TEL-1200

(not shown)

Provides twelve (12) independent media converter

connections between Fast Ethernet

™

over twisted-pair copper (one 50-pin Telco

connector) and Fast Ethernet

™

over singlemode or multimode fiber (twelve fiber

connectors, selected as a set according to network requirements).

E-TX-FX-0600

(not shown) Provides six (6) independent media converter

connections between Fast Ethernet

™

over twisted-pair copper (six RJ-45

connectors) and Fast Ethernet

™

over singlemode or multimode fiber (six fiber

connectors, selected as a set according to network requirements).

*The LinkAlert™ feature allows each media converter port to pass link faults between connected 100BASE-TX and 100BASE-FX devices.

Minneapolis, MN 55344 USA

100BASE-TX/100BASE-FX

Multi-Port Media Converter

E-TX-FX-1200, E-TEL-1200, E-TX-FX-0600

USER’S GUIDE

Fiber Cable/Connector Options* by Model:

E-TX-FX-xx00/E-TEL-1200: multimode fiber, ST connectors E-TX-FX-xx00(SC)/E-TEL-1200(SC): multimode fiber, SC connectors E-TX-FX-xx00(MT)/E-TEL-1200(MT): multimode fiber, MT-RJ connectors E-TX-FX-xx00(SM)/E-TEL-1200(SM): singlemode fiber, SC connectors E-TX-FX-xx00(LH)/E-TEL-1200(LH): singlemode fiber, SC connectors

*See page 9 for detailed specifications.

E-TX-FX-xx00 in the Network . . . . . .2

Installation . . . . . . . . . . . . . . . . . . . .4

Operation . . . . . . . . . . . . . . . . . . . . .6

Fault Isolation and Correction . . . . .8

Cable Specifications . . . . . . . . . . . . .9

Technical Specifications . . . . . . . . .11

Compliance Information . . . . . . . . .12

TP LINK

FBR LINK

POWER

ACT

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

TP LINK

TP LINK FBR LINK

ACT

FBR LINK

ACT

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

E-TX-FX-XX00 IN THE NETWORK

Each media converter port in the multi-port media converter operates independently over one isolated twisted-pair copper/fiber-optic cable link. The media converter port receives and transmits network signals in either full-duplex or half-duplex, depending upon the network devices to which the media converter port is attached.

NOTE: In Telco option (not shown), the 50-pin Telco connector concentrates up to 12 UTP connections onto one connector. This concentration of UTP ports is then broken out for connection to fiber.

RJ-45 CONNECTOR

Twisted pair connection requires two active pairs configured as straight through and/or crossover. The two active pairs in an Ethernet™ network are pins 1 & 2 and pins 3 & 6. Use only dedicated wire pairs (such as blue/white & white/blue, orange/white & white/orange) for the active pins.

NOTE: The multi-port media converter AutoCross™ feature allows either straightthrough or crossover twisted-pair copper cable to be used when connecting to 10BASE-T devices. AutoCross™ determines the characteristics of cable connections to the media converter port and then automatically configures the port to link up.

TECHNICAL SPECIFICATIONS

Standards IEEE 802.3 1998 Edition Case Dimensions 19.0" x 8.5" x 1.5" (483 mm x 216 mm x 38 mm) Environment Temperature: 0-50°C (32° to 122° F )

Humidity 10-95%, non condensing Altitude 0-10,000 feet

Power 100-240 VAC, 50/60 Hz., 1 Amp (maximum) Warranty Lifetime

DECLARATION OF CONFORMITY

Name of Mfg: Transition Networks

6475 City West Parkway, Minneapolis MN 55344 USA Model: E-TX-FX-xx00, E-TEL-xx00 Series Multi-Port Media Converter Part Number(s): E-TX-FX-0600, E-TX-FX-0600(SC), E-TX-FX-0600(SM), E-TX-FX-0600(LH),

E-TX-FX-0600(MT), E-TX-FX-1200, E-TX-FX-1200(SC), E-TX-FX-1200(SM),

E-TX-FX-1200(LH), E-TX-FX-1200(MT), E-TEL-1200, E-TEL-1200(SC),

E-TEL1200(SM), E-TEL-1200(LH), E-TEL-1200(MT)

Regulation: EMC Directive 89/336/EEC

Purpose: To declare that the E-TX-FX-0600, E-TX-FX-1200 or E-TEL-1200 to

which this declaration refers is in conformity with the following standards.

EMC-CISPR 22: 1985 Class A; EN 55022: 1988 Class A; EN 50082-1:1992; EN 60950 A4:1997; IEC 801.2, IE C 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the

above Directive(s) and Standard(s).

_September 3, 1999_____

Stephen Anderson, Vice-President of Engineering Date

Switch

Server

Twisted Pair #1

Twisted Pair #2

Straight Through

1 2

3 6

1 2

3 6

Twisted Pair #1

Twisted Pair #2

1 2

3 6

Crossover

1 2

3 6

Half-Duplex

TP LINK FBR LINK

POWER

ACT

Half-Duplex

Full-Duplex

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

Full-Duplex

TP LINK

FBR LINK

ACT

Full-Duplex

Half-Duplex

ACT

TP LINK

FBR LINK

ACT

Half-Duplex

TP LINK

FBR LINK

ACT

TP LINK

FBR LINK

ACT

Hub

Server

+ 4 hidden pages