Transact Campus PR5000X011 User Manual

Point of Sale Reader (PR5000)

Hardware Installation Guide

403-002-018 Rev A

Table 0-1: Revision History

Bb Document Part Number Rev. Description Date

403-002-018 A ECO10431. Initial Release. PENDING

403-002-018 Rev A

Federal Communications Commission (FCC) statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may

cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy, and if it is not installed and used in accordance with the instruction

manual, it may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference, in which case the

user will be required to correct the interference at his own expense.

Modifications: Any modifications made to this device that are not approved by

Blackboard Inc. may void the authority granted to the user by the FCC to operate this

equipment.

IMPORTANT NOTE: This equipment complies with the FCC radiation exposure limits set

forth for an uncontrolled environment. End users must follow the specific operating

instructions for satisfying RF exposure compliance. The antenna(s) used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all

persons and must not be co-located or operating in conjunction with any other antenna or

transmitter.

Contains:

FCC ID: VPYLB1DX Murata WLAN + Bluetooth Combo Module (LBEE5KL1DX-883)

FCC ID: WAP2005 Cypress Semiconductor Bluetooth Low-Energy Module (CYBLE-222014-01)

403-002-018 Rev A

Industry Canada Class A emission compliance statement

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de

brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

Contains:

IC: 772C-LB1DX Murata WLAN + Bluetooth Combo Module (LBEE5KL1DX-883)

IC: 7922A-2005 Cypress Semiconductor Bluetooth Low-Energy Module (CYBLE-222014-01)

Contient des IC: 772C-LB1DX and 7922A-2005

Australia and New Zealand Class A statement

Attention: This is a Class A product. In a domestic environment this product may cause radio interference

in which case the user may be required to take adequate measures.

Radiation Exposure Statement

This equipment complies with radiation exposure limits set forth for uncontrolled environment. The

antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm

from all persons and must not be collocated or operating in conjunction with any other antenna or

transmitter.

Déclaration d'exposition aux radiations

Cet appareil se conforme aux limites d'exposition aux rayonnements pour un environnement non contrôlé.

L'antenne (s) qui est utilisé pour cet émetteur doit être installé pour produire une distance de séparation

d'au moins 20 cm de toutes personnes et ne doit pas être installé à proximité ou utilisé en conjonction avec

une autre antenne ou émetteur.

403-002-018 Rev A

Note: The regulatory compliance information above can be viewed on the reader’s display. To
view this information on the reader, at the Main Menu, press the Regulatory Information
button.

403-002-018 Rev A

Contents

1 BLACKBOARD POINT OF SALE READER (PR5000) HARDWARE INSTALLATION GUIDE

1 Overview

1Features:

2 PR5000 Functional Overview

2 Inputs and Outputs: 2 Functional Overview - Bottom 3 Functional Overview - Top

4 PR5000 Mount Kit

5 INSTALLING THE PR5000 READER

5 Reader Installation Overview and Wiring Considerations

5 Wiring and Power Considerations:

6 Tabletop Installation

6 Install the reader on a tabletop

7 Wall Mount Installation

8 Installing the Mount Kit 10 Connecting Cables

11 Technical Specifications

403-002-018 Rev A

I