Traceable DIGI-SENSE 37803-96 Manual

SPECIFICATIONS
Range: –58.0 to 1832 °F –50.0 to 1000 °C Resolution: 0.1° (-9.9 to 199.9) 1° (otherwise)
OPERATION
Press and continue to hold down the trigger to take temperature readings. The unit will take temperature readings while the trigger is pressed and held (SCAN appearing on the display indicates measurements are being taken).
After the trigger is released, the last temperature measured will be displayed for approximately 7 seconds and the display will turn off automatically. HOLD will appear on the display when the trigger has been released to indicate that the unit is no longer taking temperature measurements.
SELECTING UNITS OF MEASURE
While taking measurements, press the °F button to display the temperature in °F, press the °C button to display the temperature in °C. Once the unit has turned off, the next time the trigger is pressed, unit of measure will return to the default of °C.
LASER TARGETING
ð
While taking measurement, press the button to activate laser targeting. Aim the laser approximately 1/2 inch above the desired measurement point. To turn
ð
off laser targeting, press the again. CAUTION: Eye damage may result from direct exposure to laser light.
r
r
button
BACKLIGHT
While taking measurements, press the
button to turn on the LCD backlight. Press the LCD backlight.
DISTANCE SPOT/RATIO
There are other factors that may affect measurement accuracy. The target
must completely ll the spot diameter
seen by the infrared sensor; otherwise
readings will be inuenced by the
surface surrounding the target. The ratio of the distance to the size of the spot being measured is 50:1. For example, an object’s diameter of 100mm can be measured from 5000mm.
button again to turn off the
DISPLAY MESSAGES
1” will appear on the display when the temperature being measured is outside the range of the unit.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, replace the battery with a new high quality battery (see Battery Replacement section). Low battery power can occasionally cause any number of “apparent” operational
difculties. Replacing the battery
with a new fresh battery will solve most
difculties.
BATTERY REPLACEMENT
Erratic readings, faint readings, no display, or a battery symbol appearing on the display are all indications that the battery must be replaced.
Locate the indentions on either side of the plastic case near the trigger. Open the battery compartment by pulling the rubber portion of the handle out and away from the trigger. Pull hard, it requires a good
amount of force to open the battery com­partment. Remove the exhausted battery
and replace it with a new 9-volt alkaline battery. Close the battery cover by snap­ping it shut.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
Control Company is ISO 9001:2008 Quality-Certi ied
by DNV and ISO/IEC 17025:2005 accredited as a
Calibration Laboratory by A2LA.
5 Commonwealth Ave Woburn, MA 01801
TestEquipmentDepot.com
Traceable® is a registered trademark of Control Company.
©2016 Control Company. 92-4483-00 Rev. 2 061716
TRACEABLE
INFRARED
THERMOMETER
GUN
INSTRUCTIONS
®
Loading...