Toyotomi LC-52 Owner's Manual

Adjustment Keys

Key-lock Button

Timer Key

Save Key

Extension Key

ON/OFF
Button/Lamp

Digital Indicator

OPERATION PANEL

ON/OFF Lamp —flashing : Preheating mode

key-lock Indicator —constant : Childproof Lock is on.

Temperature Indicator —constant : The Digital Indicator shows Set

constant : Heater in operation

temperature and Room temperature.

Clock Indicator —constant : The Digital Indicator shows current time.

Timer Lamp —constant : Heater in operation in timer mode.

Save Indicator —constant : The operation is in Save mode operation.

Ventilation Indicator —flashing : Oxygen level in room is insufficient. Heater

shuts off automatically.

Fuel Indicator —constant : Fuel tank empty. Only 10 minutes burning

time remaining. Digital indicator shows the
remaining burning time in minutes.
You can hear the alarm every 2 minutes.

flashing : Heater extinguished due to lack of fuel. (10

seconds alarm)

2

UNPACKING AND PLACEMENT

1. Take out heater from box carefully to avoid damage.

2. Remove all packing materials from heater.

3. Make sure all screws are tight and all parts intact.

NOTE:Save shipping carton and all packing materials for future storage of your heater.

4. When positioning your heater for use, keep it away from walls and all other materials as
illustrated below.

5. The floor should be firm and completely level. Reposition the heater, when it is not level.

NOTE:If your heater is not on a level surface, change its location. Do not attempt to prop

heater up with books or other objects.

3

FUELING

WARNING :

Use only water-clear kerosene (paraffin).
Never use gasoline or other flammable
liquids.
ALWAYS extinguish heater before refill heater
fuel tank.
Fuel heater outside the living area.

empty full

1. Open the fuel tank lid on the top of heater cabinet and lift out the
removable fuel tank. Turn the removable tank upside down and
remove the fuel tank cap.

2. Insert the straight tube of the manual siphon into the jerrycans;
insert the siphon’s flexible hose into the removable fuel tank
opening.

3. Turn the air vent knob on the top of the siphon clockwise to
close the vent. Start the flow of kerosene (paraffin) by squeezing
the bulb of the siphon vigorously six or seven times. Once flow
begins, it is no longer necessary to squeeze the bulb.

4. Check the removable tank fuel gauge while filling the tank. Stop
filling by loosening the switch button on top of the pump (turn
anti-clockwise), once the gauge indicates that the tank is full.
Never overfill the tank, especially not when the fuel is very cold
(fuel expands when it heats up).

5. Remove the siphon carefully, allowing excess kerosene (paraffin)

6. After making sure fuel tank cap is tightly fastened, invert tank

NOTE:Be careful to avoid overfilling the tank, especially with

very cold kerosene (paraffin). Overflow might occur due
to expansion when the fuel warms up.

to drain from the tube back into the jerrycans. Replace fuel tank
cap and tighten it securely. Be sure to wipe away any spilled
kerosene (paraffin) from tank and other heater parts.

and replace into heater body.

4