Toto TS170FCP User Manual
0GU3031
2007.5
®
HANDSHOWER TRIM
TS170F
™
RENESSE
Installation and Owner’s Manual
English
Español
Français
Contents
Important Safeguards---------------1
Specifications -------------------------2
Before Installation -------------------2
Set-up Drawing------------------------3
Components ---------------------------3
Installation Procedure ----------4-5
Set-up Options -----------------------6
Replacement Parts-------------------6
Warranty---------------------------------7
Thank you for your recent purchase
•
of the TOTO product . Please read
the enclosed information to ensure
the safe use of your product
.
Read these important Safeguards thoroughly before using your Hand shower
●The following symbols indicate safe and proper use of the product. Failure to observe them may result in injury or
property damage. The following table demonstrates the use of safety symbols symbols in the manual.
The symbols and their meanings are as follows.
ENGLISH
Important Safeguards
(For your safety please follow the instructions below)
Failure to observe this symbol may
Warning
Caution
Do not use hot water supply that is higher than 185°F (85°C).
Do not use steam as hot water supply.
result in serious injury.
Failure to observe this symbol may
result in injury or property damage.
Warning
Absolutely Do NOT.
Do not disassemble
Mandatory!
Do Not
If water is hotter than 185°F is used. If it is broken, property damage,
scalding, and other injuries may occur.
Do not disassemble or modify the item in any way not
described in this manual .
Do not
disassemble
If the system is broken, property damage, scalding and other injuries are likely to
occur.
Do not cause scratch to the O-ring.
Do Not
Less
than185°F
(85° C)
Caution
Do not strike or kick the product.
If the system is broken, property damage, scalding, and other
injuries may occur due to water leakage.
O-ring
Damaged O-ring may cause water leakage.
Do not use the product at temperature exceeding what local
codes allow.
If parts are damaged, property damage, scalding and other injuries
Freezing
may occur.
1
Specification
Minimum pressure
Water Supply
Pressure
Supplied Water Temperature
Water Quality
Ambient Temperature
Water Supply Connection
Humidity
Flow Rate
Depending on the model, some specifications may differ.
Maximum pressure
Before installation
20 psi (0.14MPa) (flowing pressure)
125 psi (0.86MPa) (static) Check local building code
Less than 185°F (85°C)
Water that meets National/Primary drinking water regulation
34 -104°F (2 - 40°C)
1/2” NPT (for hand shower adapter_
Maximum 90% RH
Max. 2.5 gallons per minutes (9.5L/min)
SOLD SEPARATELY
)
ENGLISH
▪ Observe all local plumbing codes.
▪ Make sure water supply is shut off.
▪ Read these instructions carefully to ensure proper installation.
▪ Check to make sure you have the following parts indicated below.
● If the water supply pressure is higher than 125psi (0.86MPa), you should buy a
reducing valve to reduce the pressure to the range of 0.2-0.3MPa.
To use the faucet comfortably, the recommended pressure is about 30-45 psi
(0.2-0.3MPa).
●To prevent being scalded due to malfunction, the cold water supply pressure must
be higher than the hot water pressure, or you can make them equal. In addition,
if you increase the pressure of the hot water, it still must be lower than that of cold
water supply side.
●To prevent being scalded due to wrong operation, it is recommended the hot water
supply temperature is 140°F (60°C).
●For ease of water flow adjustment and inspection with tools, you should prepare an
extra stop valve.
2
Loading...