CONGRATULATIONSONPURCHASINGYOURTOTALLYWICKED
|
|
TANK |
Mouthpiece |
Tank glass |
Tank base |
|
|
(with airflow adjustment) |
Top cap |
Atomizer head |
|
PRIMING YOUR TORNADO EX2 TANK
It is important to “prime” a new atomizer head before first use. Failure to do so can cause damage to the atomizer head.
Invert the tank. Holding the tank cap and glass, and gripping the airflow adjuster, unscrew and remove the tank base from the tank. Prime the atomizer head by dripping a few drops of e-liquid into its central hole to soak the wicking material visible through the hole. Screw the atomizer base back onto the tank cap and glass, then refit the tank assembly to the battery.
Priming |
1 |
2 |
3 |
Note: Leave a new atomizer head to sit in a tank full of e-liquid for five minutes before vaping. This ensures the atomizer head is fully saturated with e-liquid before use.
Filling the Tank
Hold the tank top, and remove the mouthpiece by unscrewing it. Fill the tank with e-liquid using one of the dedicated fill holes
located either side of the central air hole, do not allow e-liquid to enter the central air hole. Once filled, refit the mouthpiece.
Note: To avoid leaking, ensure an air gap of around 2mm remains above the filled liquid.
Filling |
1 |
2 |
3 |
Adjusting Airflow:
If you find air flow too airy or too tight, rotate the airflow adjuster to expose fewer or more holes. Experiment to find your preference.
Loading...