Totally wicked Skope S User Manual

USER MANUAL

CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED SKOPE S ELECTRONIC CIGARETTE KIT

QUICK START GUIDE

For those familiar with e-cigarettes, the steps below can
be followed to allow the device to be used in the shortest
possible time:

• Prime the atomizer head

• Fill the tank

• Switch the Skope S on

• Press the power button and inhale

• Charge the battery (it may not have been shipped with
a full charge)

Charging Port

USING YOUR SKOPE S

Priming the Atomizer Head

Note: It is important to “prime” a new atomizer head before rst use. Failure to do so

can cause the atomizer coil to overheat, leading to an unpleasant taste and sometimes

irreversible damage to the atomizer head requiring early replacement.

To prime the atomizer head, remove the mouthpiece from the tank by unscrewing, then

remove the glass section of the tank by pulling upwards. Unscrew the atomizer head and

prime by dripping a few drops of e-liquid onto the cotton visible through the sides of the

atomizer. After priming, screw the atomizer head back into place, replace the glass section
and screw the mouthpiece back on.

Note: Leave a new

atomizer head to sit with
the tank full of e-liquid

for ve minutes before
vaping. This ensures the

atomizer head is fully
saturated with e-liquid

before use.

Skope S
Tank

Power
Button

Skope S
Battery

Filling the Tank

Remove the mouthpiece from the tank by unscrewing.
Fill the tank with e-liquid, being careful not to overll and
avoid lling down the central airow hole. Once lled,
ret the mouthpiece.

Powering On and O:

To switch on, quickly press the power button ve times;
the indicator light will ash three times. Quickly press the power button ve times to turn
the battery o; the indicator light will ash three times.

Vaping:

Press and hold the power button as you inhale the vapour.

E-liquid Level:

To prevent the atomizer head from
becoming dry and burning prematurely,

ensure the uid level does not drop below
the uid feed holes on the atomizer, these

can be recognised by the visible parts of

cotton on the atomizer.

Charging the Battery:

The Skope S is charged by inserting the

USB cable into the charging port. The

indicator light will illuminate red while

charging. Once fully charged, the red
indicator light will switch o.

Replacing the Atomizer Head:

To replace the atomizer head, follow the
steps outlined in Priming the Atomizer

Head to remove and separate the tank.

Prime your new atomizer head and

reassemble.

PROTECTIONS

Short Circuit Protection:

If an atomizer short circuit occurs, the

indicator light will ash three times and
the Skope S will switch o. Replace the

atomizer head and charge the battery to
restore power to allow normal operation

to resume.

No Atomizer Detected:

If no atomizer head is detected when the
power button is pressed, the indicator

light will ash continuously until the power
button is released. If this happens, ensure
the atomizer head is properly tted,

referring to appropriate instructions

above.

Atomizer Head Protection:

If the power button is held down for
longer than 15 seconds while vaping, the

indicator light will ash eight times and
the Skope S will switch o. Release the

power button and charge the battery to
restore power and allow normal operation

to resume.

Kit contents:

1 x Totally Wicked Skope S

2 x BFHN 0.5ohm atomizer heads

3 x Silicone rings

1 x USB cable
1 x User manual

Manufactured in China under the authority

of Pillbox38 UK Ltd, Stanclie Street,
Blackburn, Lancashire, BB2 2QR.

Specications:

Dimensions: 14.0mm (diameter) x

113.0mm (length)

Weight: 38g

Battery capacity: 650mAh integrated
battery.
Output modes: Constant voltage
Max charging current: 1.0A
Max output voltage: 1.85V
Tank/Battery connection: All in one/
Proprietary connection.
Tank capacity: 1.2ml
Filling method: Screw top ll
Airow type: Non-adjustable
Max rell nozzle diameter: 2.8mm

ADDITIONAL PRODUCT INFORMATION

There are no reported medical side eects
with this product. If you believe you
experience a side eect, please contact
the manufacturer.

PRODUCT STORAGE AND BATTERY
PRECAUTIONS

• Store the Skope S and its accessories

away from children when not in use.

• Please only use the charging cable

provided.

• Please dispose of dead batteries
in accordance with your country’s

appropriate legislation.

• Do not charge the battery in a damp
environment, or in temperatures under

0°C or above 45°C.

• Do not use the device in temperatures

under -10°C or above 60°C.

• Do not carry batteries in a pocket or bag

with other metallic objects.

• Do not attempt to repair a faulty Skope S
battery as these are sealed units with no

serviceable parts. Attempted repairs will
void the warranty.

WARRANTY

The Skope S components have a 28 day
parts warranty, with the exception of
atomizer heads, which are consumable
items and covered by “dead on arrival”

warranty only. The USB cable supplied
has a 12-month warranty. If any parts are

found to be faulty within this time please
contact our customer service team, whose
details are below and we will arrange for a

replacement. We may require the goods to
be returned for further investigation.

Tel [phone] www.totallywicked.co.uk
Tel [phone] www.totallywicked.com
Tel [phone] www.totallywicked.de