Toshiba W704 User Manual

Video Cassette Recorder

W-704

OWNER’S MANUAL

REV FF

POWER

EJECT

PROG.TV

REC

PLAY

STOP

PAUSE/STILL

This publication is printed
on recycled paper

70971840

SAFETY PRECAUTIONS

The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsu­lated “dangerous voltage” within the
product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.

The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN
OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE
THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO

WIDE SLOT, FULLY INSERT.

Product Name: Video Cassette Recorder
Model Number: W-704

FCC Notice: “Declaration of Conformity”
This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

Contact: Toshiba America Consumer Products, Inc.
Address: 1420 Toshiba Drive, Lebanon, TN37087
Telephone: [phone]

User Installer Caution: Changes or modification made to this equipment not expressly
approved by Toshiba Corporation or parties authorized by Toshiba Corporation could
void the user’s authority to operate the equipment.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.

2

IMPORT ANT PRECAUTIONS

Save Original Packing Materials

The original shipping carton and packing materials will come in handy if you ever have to ship
your VCR. For maximum protection, repack the set as it was originally packed at the factory.

Avoid Volatile Liquid

Do not use volatile liquids, such as an insect spray, near the unit.
Do not leave rubber or plastic products touching the unit for a long time. They will mar the
finish.

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location.
When the VCR is exposed to such a change in temperature, moisture may condense on the
cylinder inside, one of its most crucial internal parts. To prevent the VCR from possible
damage, do not use the unit for at least 2 hours when there is an extreme or sudden change
in temperature.

Compatibility

This video cassette recorder (VCR) is compatible with any other VCR bearing the
mark. HQ VHS equipment is also compatible with existing, non-HQ VHS equipment.

INTRODUCTION

Copyright

It is permissible to record television programs, film, video tapes and other material only in the
event that third party copyrights and other rights are not violated.

As an E

NERGY STAR

product model meets the E

®

Partner, TOSHIBA has determined that this product or

NERGY STAR

®

guidelines for energy efficiency.

In the spaces provided below, record the Model and Serial No. located at the rear of your video
cassette recorder.

Model No. Serial No.

Retain this information for future reference.

3

IMPORTANT SAFETY
INSTRUCTIONS

CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS

GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED ON THE UNIT.
RETAIN THIS BOOKLET FOR FUTURE REFERENCE.

This set has been designed and manufactured to assure personal safety. Improper use can
result in electric shock or fire hazard. The safeguards incorporated in this unit will protect
you if you observe the following procedures for installation, use and servicing. This unit is
fully transistorized and does not contain any parts that can be repaired by the user.

DO NOT REMOVE THE CABINET COVER, OR YOU MAY BE EXPOSED TO
DANGEROUS VOLTAGE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
ONLY.

1. Read owner’s manual

After unpacking this product, read the owner’s manual carefully, and follow all
the operating and other instructions.

2. Power Sources
This product should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supply to your
home, consult your product dealer or local power company. For products
intended to operate from battery power, or other sources, refer to the operating
instructions.

3. Grounding or Polarization
This product may be equipped with a polarized alternating current line plug (a
plug having one blade wider than the other). This plug will fit into the power
outlet only one way. This is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact
your electrician to replace your obsolete outlet. Do not defeat the safety
purpose of the polarized plug.

4. Ventilation
Slots and openings in the cabinet are provided for ventilation and to ensure
reliable operation of the product and to protect it from overheating, and these
openings must not be blocked or covered. The openings should never be
blocked by placing the product on a bed, sofa, rug or other similar surface. This
product should not be placed in a built-in installation such as a bookcase or rack
unless proper ventilation is provided or the manufacturer’s instructions have
been adhered to.

5. Heat
The product should be situated away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.

4

6. Water and Moisture
Do not use this product near water - for example, near a bath tub, wash bowl,
kitchen sink, or laundry tub; in a wet basement; or near a swimming pool and
the like.

7. Cleaning
Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.

8. Power-Cord Protection
Power-supply cords should be routed so that they are not likely to be walked
on or pinched by items placed upon or against them, paying particular attention
to cords at plugs, convenience receptacles, and the point where they exit from
the product.

9. Overloading
Do not overload wall outlets; extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.

10. Outdoor Antenna Grounding
If an outside antenna or cable system is connected to the product, be sure the antenna or cable system
is grounded so as to provide some protection against voltage surges and built-up static charges. Article
810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper
grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.

INTRODUCTION

EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE

ANTENNA
LEAD IN
WIRE

GROUND
CLAMP

ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)

S2898A

ELECTRIC
SERVICE
EQUIPMENT

NEC – NATIONAL ELECTRICAL CODE

11. Power Lines
An outside antenna system should not be located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep from touching such power lines or circuits as
contact with them might be fatal.

5

IMPORTANT SAFETY
INSTRUCTIONS

12. Lightning

For added protection for this product during storm, or when it is left unattended
and unused for long periods of time, unplug it from the wall outlet and
disconnect the antenna or cable system. This will prevent damage to the
product due to lightning and power-line surges.

13. Object and Liquid Entry
Never push objects of any kind into this product through openings as they may
touch dangerous voltage points or short-out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the product.

14. Attachments
Do not use attachments not recommended by the product manufacturer as they may cause hazards.

15. Accessories
Do not place this product on an unstable cart, stand, tripod, bracket, or table.
The product may fall, causing serious injury to a child or adult, and serious
damage to the product. Use only with a cart, stand, tripod, bracket, or table
recommended by the manufacturer, or sold with the product. Any mounting of
the product should follow the manufacturer’s instructions, and should use a
mounting accessory recommended by the manufacturer.
A product and cart combination should be moved with care. Quick stops,
excessive force, and uneven surfaces may cause the product and cart
combination to overturn.

S3125A

16. Damage Requiring Service
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
a) When the power-supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions. Adjust only those

controls that are covered by the operating instructions as an improper adjustment of other controls
may result in damage and will often require extensive work by a qualified technician to restore the

product to its normal operation.
e) If the product has been dropped or damaged in any way.
f) When the product exhibits a distinct change in performance - this indicates a need for service.

17. Servicing
Do not attempt to service this product yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.

18. Replacement Parts
When replacement parts are required, be sure the service technician has used replacement parts
specified by the manufacturer or have the same characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, or other hazards.

19. Safety Check
Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to determine that the product is in proper
operating condition.

6

Contents

INTRODUCTION

Provides important notes and general
explanation of the VCR, including names of the
buttons, jacks, etc.

SAFETY PRECAUTIONS .................... 2

IMPORT ANT PRECAUTIONS.............. 3

IMPORT ANT SAFETY

INSTRUCTIONS................................... 4

Contents .............................................. 7

Identification of Controls ................... 8

• Front Panel

• Remote Control

• VCR Display

• Rear Panel

INTRODUCTION

Variable Speed Playback.................. 21

• Picture Search

• Still Picture

• Slow-motion Picture

• Frame Advance

• Double Speed Playback

• Shuttle Dial Operation

Useful Functions in T ape

Operation........................................... 23

• Counter Function

• Tape Remaining Time

• Index Search Function

RECORDING

Explains recording functions.

PREPARATION

Explains what you need to do before operating
the VCR.

How to Use the Remote Control ...... 10

Connections ...................................... 11

Auto Set Up ....................................... 14

Initial Settings Using On-screen

Display ............................................... 15

• Setting the Language

• Optional settings on the SET UP
screen

• Setting the Clock

Storing Channels on the VCR .......... 17

Video Cassette Use .......................... 19

PLAYBACK

Explains variable functions concerning
playback.

Recording a TV Program .................. 25

• Watching a TV program while
recording another

• Recording off time setting

Timer Program Recording ............... 26

3

VCR Plus+ C
VCR Plus+ C

®

system Set-up ......... 29

3

®

system Recording .. 31

Cable Box Set-up .............................. 33

®

DSS

Satellite Receiver Set-up........ 37

MTS Broadcast Compatibility.......... 41

Simulcast Recording ........................ 42

ADDITIONAL INFORMATION

Multi Brand Remote Control ............ 43

Before Calling Service Personnel ... 45

Specifications ................................... 47

Accessories....................................... 47

Playback ............................................ 20

•19µ HEAD

LIMITED W ARRANTY ........................ 48

7

INTRODUCTION

Identification of Controls

See the page in for details.
This manual shows the names of buttons in italics.

Front Panel

CHANNEL

EJECT

POWER

LINE IN 2

19
15

POWER

LINE IN 2

VIDEO L-MONO-AUDIO-R

VIDEO jack

LINE IN 2 AUDIO

(L/MONO, R) jacks

Remote Control

To operate this VCR.

To operate your TV.

Number buttons

REMAIN/COUNTER

VCR Plus+

25

c EJECT

CHANNEL

REC

VCR

TV

I.SELECT

DISPLAY

SP/SLP

REC

REW

SLOW

PROG.

EJECT

CANCEL

Cassette compartment

REC

Remote sensor

10

25

14
43

VCR TV

23

25
25

23
23

1

4

78

I.SELECT

0

REMAIN/

DISPLAY

COUNTER

SP/SLP

REC

COUNT RESET

25

SLOW

PLAY/x2

CURSOR

STOP

25

*

20
21

PROG. ENTER

CANCEL

+

15

A.SELECTVCR Plus

EJECT INDEX

31
19
28

65

9

100

19

POWER

CH/TRK

TV VOL

TV/VCR

TIMER

FFREW

PAUSE/STILL

19

µ

/

CH

POWER

CABLE
BOX

PLAY

STOP

PAUSE/STILL

REV

(

FWD

)

PAUSE/STILL

VCR display

POWER
CH/TRK

100

TV VOL

TV/VCR

15
25

18

43

25

COUNT RESET
TIMER
PLAY/x2
FF

27

*

20

*

20

PAUSE/STILL
STOP

ENTER

*

20

15

POWER (CABLE BOX)
CH (CABLE BOX)

PLAY

STOP

SHUTTLE

9

23

21

19

µ

20

35

20
20

22

21

35

8

A.SELECT

41

INDEX

24

* These buttons are used to control the
cursor on the screen.