TOSHIBA VNR104C11S-INV User Manual

All information is subject to change without notice. Please read bottom notes.

TOSHIBA MATSUSHITA DISPLAY TECHNOLOGY

PRODUCT INFORMATION

INVERTER for LTD104C11S

LTD121GA0S
LTD121C30S

VNR104C11S-INV

TENTATIVE

MECHANICAL SPECIFICATIONS

Item Specifications
Dimensional Outline (Typ.) 110.0(W) x 22.0(H) x 10.0(Max.)(D) mm
Applicable TFT Module LTD104C11S,LTD121GA0S,LTD121C30S
Weight (approximately) 25g(Typ.)

ABSOLUTE MAXIMUM RATINGS *1

Item Symbol Min. Max. Unit
Supply Voltage VIN 0 14.0 V
Input Voltage

Operating Temperature *2
Storage Temperature *2
Storage Humidity *2

*1 : Do not exceed the maximum rating values under the worst probable conditions
taking into account the supply voltage variation, input voltage variation,
variation in part constants, ambient temperature and so on.
Otherwise the inverter unit may be damaged.
*2 : Wet bulb temperature should be 39°C max.,and no condensation of water.

VON/V

T

Top

H

stg

OFF

-1 VIN+1 kHz

-10 65 °C

-20 80 °C
10 90 %(RH)

ELECTRICAL SPECIFICATION *3

Item Symbol Min. Typ. Max. Unit
Supply Voltage

Input Current
Open Output Voltage
Frequency

Volume Max. --- 12.0 --- mA(rms) Output Current *4
Volume Min.

*3 : The characteristics without remarks are measured on condition with Vin=12V and VR-VR:short.
*4 : This is the sum of two output currents.

V

V

OPEN

VON 2.5 --- VIN V V ON/OFF Signal Voltage

V

IN

I

IN

f

IFL

OFF

10.8 12.0 13.2 V

--- TBD TBD mA

1500 --- --- Vo-p

50 55 60 kHz

--- 3.0 --- mA(rms)

--- --- 0.7 V

*The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by
Toshiba Matsushita Display Technology or other rights of the third parties which may result from its use. No license is granted by
implication or otherwise under any patent or patent rights of Toshiba Matsushita Display Technology or others.

*The information contained herein may be changed without prior notice. It is therefore advisable to contact Toshiba Matsushita
Display Technology before proceeding with the design of equipment incorporating this product.

(1/4) 2003-02-07 (Ver.1.0)

DIMENSIONAL OUTLINE

VNR104C11S-INV

Unit : mm
Standard tolerance : ±0.5

(2/4) 2003-02-07 (Ver.1.0)