Toshiba U2M-008GT, U2M-016GT, U2M-004GT User Manual

USB Flash Memory U2M Security Software Installation Manual

USB Flash Memory

TransMemory™

U2M-016GT

U2M-008GT

U2M-004GT

Security Software Installation Manual

For U2M series

USB Flash Memory U2M Security Software Installation Manual

Table of Contents

Chapter 1: Introduction....................................................................................... 3

Chapter 2: Required System Configuration ........................................................ 5

Chapter 3: How to Install the Security Software ................................................. 6

1. Installing the security software ....................................................................... 6

1.1 Installing the security software ..................................................................... 6

Chapter 4: How to Use the Security Software .................................................. 12

1. Starting up the security software and formatting .......................................... 14

1.1 Starting up the security software ................................................................ 14

1.2 Formatting using the security software ....................................................... 18

2. Changing the Security Software Password and Log In/Log Out................... 21

2.1 Changing the password using the security software .................................. 21

2.2 Logging into the Privacy Zone using the security software......................... 25

2.3 Logging out of the Privacy Zone using the security software...................... 26

USB Flash Memory U2M Security Software Installation Manual

Chapter 1: Introduction

Thank you for purchasing TransMemory™ USB flash memory. It has the following features.

・It is USB flash memory employing Toshiba’s NAND flash memory. It can be used as a removable disk for a personal computer.

・It employs security software, allowing data that has been saved in the memory to be password-protected.

・Since it is bus-powered, an AC power adapter is not required.

* You can make full use of data that you have saved, but under copyright law, the rights of copyright holders may not be violated. * You connect plural products to a PC, and please do not operate security software. Security software works only about this product one connected to a PC effectively. * You connect plural products to a PC, and please do not operate security software. Security software works only about this product one connected to a PC effectively. * When formatting this flash memory using the Security software, please do not subject it to shaking/impact, turn off the power to your computer, restart your computer or put it into Standby or Hibernate mode. If one of the above operations has been performed while the flash memory was being formatted using the security software, please reformat the flash memory using the security software. * This flash memory may stop functioning properly if one of the following operations is performed while the security software is enabled and the Privacy Zone is in use. ・Restarting your computer or resuming from Standby or Hibernate mode If one of these operations has been performed, disconnect the flash memory from your computer and reconnect it, and then log back into the Privacy Zone. * If you are using the Windows Vista® operating system and have enabled ReadyBoost™ to use the Pubic Zone, you may find at times that you are unable to log into the Privacy Zone. If this happens, disable ReadyBoost™, disconnect the flash memory from your computer and reconnect it, and then log back into the Privacy Zone.

USB Flash Memory U2M Security Software Installation Manual

* If you are using the Windows Vista® operating system, do not enable ReadyBoost™ to use the Privacy Zone.

This document describes how to install TransMemory™, how to use it, and other information. Before using the product, be sure to read it thoroughly to ensure correct use.

* The images depicted in this manual may differ from the actual product. * The design, specifications, product manual, and related information are subject to change without notice.

Trademarks

・Microsoft® and Windows® are trademarks, registered in the United States and other countries, of Microsoft Corporation of the U.S. ・ Intel® and Pentium® are trademarks or registered trademarks of Intel Corporation in various nations. ・Other companies and products mentioned herein are trademarks or registered trademarks of their respective owners.

USB Flash Memory U2M Security Software Installation Manual

Chapter 2: Required System Configuration

The following are required to properly operate this product:

- Required hardware

 CPU: Intel Pentium II 266MHz or higher  Available hard disk space of at least 800 KB  USB Specification-compliant USB port (Operation on self-built or modified PCs

cannot be guaranteed.)

- Required operating systems

 Microsoft® Windows® 2000 Professional Service Pack 4 or greater  Microsoft® Windows® XP Professional Service Pack 2 or greater  Microsoft® Windows® XP Home Edition Service Pack 2 or greater

 Microsoft® Windows Vista® Ultimate  Microsoft® Windows Vista® Enterprise  Microsoft® Windows Vista® Business  Microsoft® Windows Vista® Home Premium  Microsoft® Windows Vista® Home Basic

For Microsoft Windows XP or Microsoft Windows 2000, be sure to first log in as a user belonging to the Administrators group. If attempting to log in as a User, an error may result. The product does not work with any operating system other than Microsoft Windows.

USB Flash Memory U2M Security Software Installation Manual

Chapter 3: How to Install the Security Software

This chapter describes how to install the security software to use this product.

Be sure to install it correctly in accordance with the following explanation.

1. Installing the security software

Be sure to install the security software when TransMemory™ is connected to

the computer. Close all other applications.

1.1 Installing the security software

1) Start up the computer.

2) Access the Web download page.

3) Double click on the applicable file.

4) Click on “Save” in the dialog box shown here.

USB Flash Memory U2M Security Software Installation Manual

5) A dialog box asking where the software is to be saved appears. Select on “Desktop”.

6) When the download is complete, the following dialog box appears. Click “Close”.

USB Flash Memory U2M Security Software Installation Manual

7) On the desktop, the downloaded software named “U2LM_SecuritSoft_305.zip” appears as a new executable file. Double click on the icon.

8) It right-clicks in the icon of the security software installation program. When the following dialog box appears, and click “Extract All…”.

+ 18 hidden pages