Toshiba SD-C2502 User Manual

TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA

SD-C2502

DVD-ROM MOBILE DRIVE

USER MANUAL

CONTENTS

Introduction..............................................................................1

Setup ........................................................................................3

Using the DVD-ROM ................................................................4

Troubleshooting.......................................................................6

Specifications ..........................................................................7

Drive Connectors................................................................... 10

INTRODUCTION – SD-C2502

General Features

100ms Average Access Time (DVD)

Multimedia PC-3 Spec Compliant

RPC2 Compliant

Drawer Type Manual Load/ Electrical Release

8x sampling & digital filter for CD-Audio

CD-R and CD-RW Compatible

Drive Speed

DVD 8X
CD-ROM 24X

BUS Interface ATAPI

Types of Disc Formats Supported –

DVD-ROM
DVD-5 (single-sided, single layered)

DVD-9 (singled-sided, double layered)
DVD-10 (double-sided, single layered)
DVD-18 (double-sided, double layered
DVD-R (read, single border)

CD CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, MIXED MODE CD, CD-I,

CD-I Bridge (Photo-CD, Video-CD), Multi-session (Photo-CD Disc, CD-Extra, Portfolio, CD-R,
CD-RW), CD-R (read), CD-RW (read)

Front Panel

1

Figure 1.SD-C2502 DVD-ROM Front Panel

Eject Button The EJECT button is used to open the disc tray so you can install or remove a disc

Busy Indicator When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it

attempts to locate the disc. One of the following will occur:

• BUSY light goes out. The DVD-ROM drive is ready to read data from the disc.

• BUSY light flashes slowly. The disc may be dirty.

• BUSY light remains ON. The DVD-ROM is accessing data.

• BUSY light remains ON indefinitely. The DVD-ROM is experiencing an error.

Emergency The emergency eject hole is to be used only when the DVD tray will not open when
Eject Hole EJECT button is pressed.

DVD Tray Insert DVD Disc in tray