Toshiba RAS-H10BKCV-V, RAS-H13BKCV-V, RAS-H18BKCV-V, RAS-H10BACV-V, RAS-H13BACV-V Owner's Manual

...
OWNER’S MANUAL
R410A
AIR CONDITIONER (SPLIT TYPE)
For general public use
1118350204
ENGLISHENGLISH
ENGLISHTIẾNG VIỆT
Outdoor unit RAS-H10,13,18BACV-V
HƯỚNG DẪN SỬ DỤNG
MÁY ĐIỀU HÒA KHÔNG KHÍ (Loại 2 khối rời)
Sử dụng cho mục đích thông thường Bộ phận trong nhà (Dàn lạnh)
RAS-H10,13,18BKCV-V Bộ phận ngoài trời (Dàn nóng)
RAS-H10,13,18BACV-V
Press
1
: Move the louver in
the desired vertical direction.
Press
2
: Swing the air automatically and press again to stop.
For horizontal direction, adjust
3
manually.
Note:
Do not move the louver manually by others.
The louver may automation positioning by some operation mode.
.
j
TIMER (White)
k
OPERATION (White)
PRECAUTIONS FOR SAFETY
DANGER
Do not install, repair, open or remove the cover. It may expose you to dangerous voltages. Ask the dealer or the specialist to do this.
Turning off the power supply will not prevent potential electric shock.
The appliance shall be installed in accordance with national wiring regulation.
Means for disconnection from the supply having a contact separation of at least 3 mm in all poles must be incorporated in the fixed wiring.
WARNING
Do not expose your body directly to cool air for a long time.
Do not insert your fnger or any article into the air inlet/outlet.
When an abnormality (burning smell, etc.) occurs, stop the air conditioner and disconnect the power supply or turn off the breaker.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not use any refrigerant different from the one specifed (R410A) for complement or replacement. Otherwise, abnormally high pressure may be generated in the refrigeration cycle, which may result in a failure or explosion of the product or an injury to your body.
CAUTION
Do not wash the unit with water. It may cause an electric shock.
Do not use this air conditioner for other purposes such as preserving food, breeding animal, etc.
Do not step or put anything on the indoor/outdoor unit. It may cause an injury or damage the unit.
Do not touch aluminium fn because it may cause an injury.
Before cleaning the unit, turn off the main switch or the circuit breaker.
When the unit won’t be used for a long time, turn off the main switch or the circuit breaker.
It is recommended that maintenance be performed by a specialist when the unit has been operated for a long time.
The manufacturer shall not assume any liability for the damage caused by not observing the description of this manual.
Preparing Filters
1. Open the air inlet grille and remove the air f lters.
2. Attach the f lters. (see detail in the accessory sheet).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type) following the (+) and (–) positions.
Clock Setup
1. Push
by tip of the pencil.
If timer indication is f ashing, go to the next step 2.
2. Press
or : adjust the time.
3. Press
: Set the time.
Remote Control Reset
Push by tip of the pencil or
1. Remove the batteries.
2. Press
.
3. Insert the batteries.
j Infrared signal emitter k Start/Stop button l Mode select button (MODE) m Temperature button (TEMP) n Fan speed button (FAN) o Swing louver button (SWING) p Set louver button (FIX) q On timer button (ON) r Off timer button (OFF) s Setup button (SET)
Clear button (CLR) Memory and Preset button (PRESET) One-Touch button (ONE-TOUCH) High power button (Hi-POWER) Power selection button (POWER-SEL) Quiet button (QUIET) Comfort sleep button (COMFORT SLEEP) Filter reset button (FILTER) Set clock button (CLOCK) Check button (CHECK) Reset button (RESET)
SWING
FAN
FIX
QUIET
Hi POWER
ONE-TOUCH
COMFORT
SLEEP
POWER-SEL
q
j
k
l p
Note:
• The provided Remote Controller is a wireless type, which also can be used as a wire. Please see “How to Connect The Remote Controller for Wired Operation” located in installation instruction, in case of wired control is required.
• In wire operation, remote controller will return to initial condition (PRESET, TIMER and CLOCK will return to initial condition) when user shutdown power supply of Air conditioner.
12
13
15
17
20
19
21
18
11
16
14
m
n
s
o
r
21
18
11
16
14
12
13
15
17
20
19
Press the “ONE-TOUCH” button for fully automated operation that is customized to the typical consumer preferences in your region of the world. The customized settings control temperature air f ow strength, air f ow direction and other settings to provide you alternate contact with “ONE-TOUCH” of the button. If you prefer other settings you can select from the many other operating functions of your Toshiba unit.
Press
ONE-TOUCH
: Start the operation.
To automatically select cooling or fan only operation
1. Press
MODE
: Select A.
2. Press
: Set the desired temperature.
3. Press
FAN
: Select AUTO, LOW , LOW+ , MED , MED+ ,
or HIGH
.
1. Press
MODE
: Select Cool or Fan only .
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Fan Only: No temperature indication
3. Press
FAN
: Select AUTO, LOW , LOW+ , MED , MED+ ,
or HIGH .
COOLING / FAN ONLY OPERATION
7
AUTOMATIC OPERATION
6
ONE-TOUCH
5
PREPARATION BEFORE USE
2
INDOOR UNIT DISPLAY
1
REMOTE CONTROL
4
AIRFLOW DIRECTION
3
1
Loading...
+ 3 hidden pages