Toshiba RAS-16SKV2-E, RAS-10SAV2-E, RAS-10SKV2-E, RAS-13SKV2-E, RAS-16SAV2-E Owners Manual

...

OWNER’S MANUAL

1110250165.indb 1

10/27/09 3:58:40 PM

ENGLISH

ESPAÑOL

FRANÇAIS

ITALIANO

DEUTSCH

PORTUGUÊS

POLSKI

ÿESKY

HRVATSKI

MAGYAR

NEDERLANDS

AIR CONDITIONER (SPLIT TYPE)

For general public use

Indoor unit

RAS-10, 13, 16SKV2 Series

Outdoor unit

RAS-10, 13, 16SAV2 Series

ΕΛΛΗΝΙΚΑ

SVENSKA

SUOMI

NORSK

DANSK

ROMÂNĄ

БЪЛГАРСКИ

EESTI

LATVISKI

SLOVENÿINA

SLOVENŠÿINA

1110250165.indb 1

1110250165

10/27/09 3:58:40 PM

PRECAUTIONS FOR SAFETY

1110250165.indb 2

10/27/09 3:58:48 PM

• Do not install, repair, open or remove the cover. It may expose you to dangerous voltages. Ask the dealer or the specialist to do this.

• Turning off the power supply will not prevent potential electric shock.

DANGER

WARNING

CAUTION

INDOOR UNIT DISPLAY

Hi POWER FILTER PRE.DEF TIMER OPERATION

PREPARATION BEFORE USE

Preparing Filters

1. Open the air inlet grille and remove the air ﬁ lters.

2. Attach the ﬁ lters. (see detail in the accessory sheet).

Loading Batteries

1. Remove the battery cover.

2. Insert 2 new batteries (AAA type) following the (+) and (–) positions.

Clock Setup

1. Push CLOCK O by tip of the pencil.

2. Press

3. Press

Remote Control Reset

1. Remove the battery.

2. Press

3. Insert the battery.

AIRFLOW DIRECTION

• The appliance shall be installed in accordance with national wiring regulation.

• Means for disconnection from the supply having a contact separation of at least 3 mm in all poles must be incorporated in the ﬁ xed wiring.

• Do not expose your body directly to cool air for a long time.

• Do not insert your ﬁ nger or any article into the air inlet/outlet.

• When an abnormality (burning smell, etc.) occurs, stop the air conditioner and disconnect the power supply or turn off the breaker.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not wash the unit with water. It may cause an electric shock.

• Do not use this air conditioner for other purposes such as preserving food, breeding animal, etc.

• Do not step or put anything on the indoor/outdoor unit. It may cause an injury or damage the unit.

• Do not touch aluminium ﬁ n because it may cause an injury.

• Before cleaning the unit, turn off the main switch or the circuit breaker.

• When the unit won’t be used for a long time, turn off the main switch or the circuit breaker.

• It is recommended that maintenance be performed by a specialist when the unit has been operated for a long time.

1 Hi POWER (Green) 2 FILTER (Orange) 3 PRE.DEF

(DE-FROST) (Orange) 4 TIMER (Yellow)

RESET

5 OPERATION (Green)

6 RESET button

SET

: Set the time.

OFF

: adjust the time.

Press

FIX

: Move the louver in

the desired vertical direction.

SWING

Press

: Swing the air automatically and press again to stop.

REMOTE CONTROL

1 Infrared signal emitter 2 Start/Stop button 3 Mode select button (MODE) 4 Temperature button (TEMP) 5 Fan speed button (FAN) 6 Swing louver button (SWING) 7 Set louver button (FIX) 8 On timer button (ON) 9 Off timer button (OFF) ! Sleep timer button (SLEEP) " Setup button (SET) # Clear button (CLR) $ Memory and Preset button (PRESET) % One Touch button (ONE-TOUCH) & High power button (Hi-POWER) ( Economy button (ECO) ) Quiet button (QUIET) ~ Comfort sleep button

(COMFORT SLEEP)

+ Filter reset button (FILTER) , Clock Reset button (CLOCK)

- Check button (CHK)

ONE-TOUCH

Press the “ONE-TOUCH” button for fully automated operation that is customised to the typical consumer preferences in your region of the world. The customised settings control temperature air ﬂ ow strength, air ﬂ ow direction and other settings to provide you alternate contact with “ONETOUCH” of the button. If you prefer other settings you can select from the many other operating functions of your Toshiba unit.

Press

To automatically select cooling, heating, or fan only operation

1. Press

A C

2. Press

1. Press

2. Press

3. Press

For dehumidiﬁ cation, a moderate cooling performance is controlled automatically.

1. Press

2. Press

To automatically control room temperature and airﬂ ow for faster cooling or heating operation (except in DRY and FAN ONLY mode)

Press

ONE-TOUCH

: Start the operation.

AUTOMATIC OPERATION

MODE

: Select A.

TEMP

: Set the desired temperature.

COOLING / HEATING / FAN ONLY OPERATION

MODE

: Select Cool , Heat , or Fan only .

TEMP

: Set the desired temperature.

Cooling: Min. 17oC, Heating: Max. 30oC, Fan Only: No temperature indication

MED+ , or HIGH .

FAN

: Select AUTO, LOW , LOW+ , MED ,

DRY OPERATION (COOLING ONLY)

MODE

: Select Dry .

TEMP

: Set the desired temperature.

Hi-POWER OPERATION

Hi-POWER

: Start and stop the operation.

% 2 )

6 7 8 !

PRESET

ONE-TOUCH

QUIET

SWING

TIMER

SLEEP

TEMP

FIX Hi-POWER ECO

FILTER

CHK

FAN

5 4

MODE

3 ~

COMFORT

SLEEP

& (

CLR

OFF

CLOCK

# 9

SET

" ,

1110250165.indb 2

For horizontal direction, adjust

manually.

Note:

• Do not move the louver manually by others.

• The louver may automation positioning by come operation mode.

ECO OPERATION

To automatically control room to save energy (except in DRY and FAN ONLY mode)

Press Note: Cooling operation; the set temperature will increase automatically 1

ECO

: Start and stop the operation.

degree/hour for 2 hours (maximum 2 degrees increase). For heating operation the set temperature will decrease.

10/27/09 3:58:48 PM

1110250165.indb 3

10/27/09 3:58:51 PM

TEMPORARY OPERATION

In case of the misplaced or discharged remote control

• Pressing the RESET button, the unit can start or stop without using the remote control.

• Operation mode is set on AUTOMATIC operation, preset temperature is 24°C and fan operation is automatic speed.

TIMER OPERATION

Setting the ON Timer Setting the OFF Timer

Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.

Setting Daily Timer

• During the daily timer is activating, both arrows ( , ) are indicated.

Note:

• Keep the remote control in accessible transmission to the indoor unit;

• The setting will be saved for the next same operation.

PRESET OPERATION

Set your preferred operation for future use. The setting will be memorized by the unit for future operation (except airﬂ ow direction).

1. Select your preferred operation.

2. Press and hold The P mark displays.

3. Press

AUTO RESTART OPERATION

To automatically restart the conditioner after the power failure (Power of the unit must be on.)

Setting

1. Press and hold the RESET button on the indoor unit for 3 seconds to set

• Do not operate ON timer and OFF timer.

2. Press and hold the RESET button on the indoor unit for 3 seconds to

QUIET OPERATION

To operate at super low fan speed for quiet operation (except in DRY mode)

Press

Note: Under certain conditions, QUIET operation may not provide adequate

COMFORT SLEEP OPERATION

To save energy while sleeping, automatically control air ﬂ ow and automatically turn OFF.

Press

Note: The cooling operation, the set temperature will increase automatically

SLEEP TIMER OPERATION

To start the sleep timer (OFF timer) operation Press

Press

otherwise, the time lag of up to 15 minutes will occur.

the operation. (3 beep sound and OPERATION lamp blink 5 time/sec for 5 seconds)

cancel the operation. (3 beep sound but OPERATION lamp does not blink)

cooling or heating due to low sound features.

1 degree/hour for 2 hours (maximum 2 degrees increase). For heating operation, the set temperature will decrease.

: Set the desired ON timer.

SET

: Set the timer. Press

CLR

: Cancel the timer. Press

: Set the ON timer.

OFF

: Set the OFF timer.

PRESET

for 3 seconds to memorize the setting.

PRESET

: Operate the preset operation.

QUIET

: Start and stop the operation.

COMFORT

SLEEP

: Select 1, 3, 5 or 9 hrs for OFF timer operation.

SLEEP

: Select 1, 3, 5 or 9 hrs for OFF timer operation.

Press

( or ) mark ﬂ ashing.

OFF

: Set the desired OFF timer.

SET

: Set the timer.

CLR

: Cancel the timer.

SET

button during the

MAINTENANCE

Firstly, turn off the circuit breaker.

Filter Reset (Some models only)

FILTER lamp lights on; the ﬁ lter must be cleaned. To turn off the lamp, push the RESET button on the indoor unit or the FILTER button on the remote control.

Indoor Unit and Remote Control

• Clean the indoor unit and the remote control with a wet cloth when needed.

• No benzine, thinner, polishing powder or chemically-treated duster.

SELF CLEANING OPERATION (COOL AND DRY OPERATION ONLY)

To protect bad smell caused by the humidity in the indoor unit.

1. If the

2. To stop the unit immediately, press the

Note:

• SELF CLEANING operation is default setting from factory.

• To cancel this function, please contact the supplying retail dealership.

1. Three-minute protection feature: To prevent the unit from being activated

2. Preheating operation: Warm up the unit for 5 minutes before the heating

3. Warm air control: When the room temperature reaches the set

4. Automatic defrosting: Fans will stop during defrost operation.

5. Heating capacity: Heat is absorbed from outdoors and released into

6. Consideration for accumulated snow: Select the position for outdoor unit

7. Some minor cracking sound may occur when unit operating. This is

Air conditioner operating conditions

Operation

Heating –15°C ~ 24°C Less than 28°C Cooling –10°C ~ 46°C 21°C ~ 32°C Dry –10°C ~ 46°C 17°C ~ 32°C

• The power main switch is

• The circuit breaker is

• Stoppage of electric current

• ON timer is set.

To separate using of remote control for each indoor unit in case of 2 air conditioner are installed nearly.

Remote Control B Setup.

1. Press RESET button on the indoor unit to turn the air conditioner ON.

2. Point the remote control at the indoor unit.

3. Push and hold

4. Press

Note: 1. Repeat above step to reset Remote

2. Remote Control A has not “A” display.

3. Default setting of Remote Control from

button is pressed once during “Cool” or “Dry” mode, the fan will continue to run for other 20 minutes, then it will turn off automatically. This will reduce the moisture in the indoor unit.

3 times within 30 seconds.

OPERATION AND PERFORMANCE

for 3 minutes when suddenly restarted or switched to ON.

operation starts.

temperature, the fan speed is automatically reduced and the outdoor unit will stop.

the room. When the outdoor temperature is too low, use another recommended heating apparatus in combination with the air conditioner.

where it will not be subjected to snow drifts, accumulation of leaves or other seasonal debris.

normal because the cracking sound may be caused by expansion/ contraction of plastic.

Note: Item 2 to 6 for Heating model

Temp.

Outdoor Temperature

Room

Temperature

TROUBLESHOOTING (CHECK POINT)

The unit does not operate.

turned off.

activated to cut off the power supply.

Cooling or Heating is abnormally low.

• The ﬁ lters are blocked with dust.

•

The temperature has been set improperly.

• The windows or doors are opened.

• The air inlet or outlet of the outdoor unit is blocked.

• The fan speed is too low.

• The operation mode is FAN or DRY.

REMOTE CONTROL A-B SELECTION

CHK O

pencil. “00” will be shown on the display.

“00” will disappear and the air conditioner will turn OFF. The Remote Control B is memorized.

Control to be A.

factory is A.

button on the Remote Control by the tip of the

MODE

during pushing

CHK O

. “B” will show on the display and

EN ES FR IT DE PT PL CZ CR HU NL GR SV FI NO DK RO BG EE LV SK SI

1110250165.indb 3

10/27/09 3:58:51 PM

+ 5 hidden pages