Toshiba RAS-13SA, RAS-13SK, RAS-24SKHP-ES, RAS-10SA, RAS-10SK Owners Manual

...

OWNER’S MANUAL

025045-24Lang.indb 

/6/09 2:30:30 PM

ENGLISH

ESPAÑOL

FRANÇAIS

ITALIANO

DEUTSCH

PORTUGUÊS

POLSKI

ÿESKY

PУCСКИЙ

HRVATSKI

MAGYAR

TÜRKÇE

NEDERLANDS

AIR CONDITIONER (SPLIT TYPE)

For general public use

Indoor unit

RAS-10, 13SK Series

Outdoor unit

RAS-10, 13S Series

025045-24Lang.indb 

ΕΛΛΗΝΙΚΑ

SVENSKA

SUOMI

NORSK

DANSK

ROMÂNĄ

БЪЛГАРСКИ

EESTI

LATVISKI

SLOVENÿINA

SLOVENŠÿINA

025045

/6/09 2:30:30 PM

PRECAUTIONS FOR SAFETY

025045-24Lang.indb 2

/9/09 2:46:02 PM

•

Do not install, repair, open or remove the cover. It may expose you

to dangerous voltages. Ask the dealer or the specialist to do this.

•

Turning off the power supply will not prevent potential electric

shock.

•

DANGER

WARNING

CAUTION

INDOOR UNIT DISPLAY

Models: RAS-3SKP Series, 3SKHP Series

Hi POWER FILTER PRE. DEF TIMER OPERATION

Models: RAS-0SKP Series, 0SKHP Series

CLEANING

RESET TIMER OPERATION

32 1

PREPARATION BEFORE USE

Preparing Filters

. Open the air inlet grille and remove the air ﬁ lters.

2. Attach the ﬁ lters. (see detail in the accessory sheet).

Loading Batteries

. Remove the battery cover.

2. Insert 2 new batteries (AAA type) following the (+) and (–) positions.

Clock Setup

. Push CLOCK

2. Press

3. Press

Remote Control Reset

. Remove the battery.

2. Press

3. Insert the battery.

AIRFLOW DIRECTION

Press

desired vertical direction.

Press

automatically and press again to stop.

For horizontal direction, adjust

manually.

Note:

• Do not move the louver manually by others.

• The louver may automation positioning by come operation mode.

The appliance shall be installed in accordance with national wiring

regulation.

•

Means for disconnection from the supply having a contact

separation of at least 3 mm in all poles must be incorporated in the ﬁ xed wiring.

•

Do not expose your body directly to cool air for a long time.

•

Do not insert your ﬁ nger or any article into the air inlet/outlet.

•

When an abnormality (burning smell, etc.) occurs, stop the air

conditioner and disconnect the power supply or turn off the breaker.

•

Do not wash the unit with water. It may cause an electric shock.

•

Do not use this air conditioner for other purposes such as

preserving food, breeding animal, etc.

•

Do not step or put anything on the indoor/outdoor unit. It may

cause an injury or damage the unit.

•

Do not touch aluminium ﬁ n because it may cause an injury.

•

Before cleaning the unit, turn off the main switch or the circuit

breaker.

•

When the unit won’t be used for a long time, turn off the main

switch or the circuit breaker.

•

It is recommended that maintenance be performed by a specialist

when the unit has been operated for a long time.

1 Hi POWER (Green)

by tip of the pencil.

OFF

SET

: Set the time.

: adjust the time.

2 FILTER (Orange) 3 PRE DEF (DE-FROST) (Orange)

(SKHP Series)

3 FAN-ONLY (Orange) (SKP Series) 4 TIMER (Yellow) 5 OPERATION (Green)

RESET

6 RESET button

1 OPERATION (Green) 2 TIMER/CLEANING (Yellow) 3 RESET button

A C

FIX

: Move the louver in the

SWING

: Swing the air

REMOTE CONTROL

PRESET

ONE-TOUCH

QUIET

SWING

TIMER

SLEEP

TEMP

FIX Hi-POWER ECO

FILTER

CHK

FAN

MODE

COMFORT

SLEEP

CLR

OFF

SET

CLOCK

1 Infrared signal emitter 2 Start/Stop button 3 Mode select button (MODE) 4 Temperature button (TEMP) 5 Fan speed button (FAN) 6 Swing louver button (SWING) 7 Set louver button (FIX) 8 On timer button (ON) 9 Off timer button (OFF) ! Sleep timer button (SLEEP) " Setup button (SET) # Clear button (CLR) $ Memory and Preset button (PRESET) % One Touch button (ONE-TOUCH) & High power button (Hi-POWER) ( Economy button (ECO) ) Quiet button (QUIET) ~ Comfort sleep button (COMFORT SLEEP) + Filter reset button (FILTER) , Clock Reset button (CLOCK)

- Check button (CHK)

ONE-TOUCH

Press the “ONE-TOUCH” button for fully automated operation that is customised to the typical consumer preferences in your region of the world. The customised settings control temperature air ﬂ ow strength, air ﬂ ow direction and other settings to provide you alternate contact with “ONE-TOUCH” of the button. If you prefer other settings you can select from the many other operating functions of your Toshiba unit.

ONE-TOUCH

Press

AUTOMATIC OPERATION

To automatically select cooling, heating, or fan only operation . Press

2. Press

COOLING / HEATING / FAN ONLY OPERATION

. Press

2. Press Cooling: Min. 7

3. Press HIGH .

DRY OPERATION

For dehumidiﬁ cation, a moderate cooling performance is controlled automatically.

. Press

2. Press

Hi-POWER OPERATION

To automatically control room temperature and airﬂ ow for faster cooling or heating operation (except in DRY and FAN ONLY mode)

Press

ECO OPERATION

To automatically control room to save energy (except in DRY and FAN ONLY mode)

Press

Note: Cooling operation; the set temperature will increase automatically  degree/

: Start the operation.

MODE

: Select A.

TEMP

: Set the desired temperature.

MODE

: Select Cool , Heat , or Fan only .

TEMP

: Set the desired temperature.

C, Heating: Max. 30oC, Fan Only: No temperature indication

FAN

: Select AUTO, LOW , LOW+ , MED , MED+ , or

MODE

: Select Dry .

TEMP

: Set the desired temperature.

Hi-POWER

: Start and stop the operation.

ECO

: Start and stop the operation.

hour for 2 hours (maximum 2 degrees increase). For heating operation the set temperature will decrease.

% 2 )

6 7 8 !

5 4 3 ~

& (

# 9 "

025045-24Lang.indb 2

/9/09 2:46:02 PM

025045-24Lang.indb 3

/9/09 2:46:06 PM

TEMPORARY OPERATION

In case of the misplaced or discharged remote control

• Pressing the RESET button, the unit can start or stop

without using the remote control.

• Operation mode is set on AUTOMATIC

operation, preset temperature is 24°C and fan operation is automatic speed.

TIMER OPERATION

Setting the ON Timer Setting the OFF Timer

PressON : Set the desired ON timer.

Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.

Setting Daily Timer

• During the daily timer is activating, both arrows ( , ) are indicated.

Note:

• Keep the remote control in accessible transmission to the indoor unit;

• The setting will be saved for the next same operation.

Set your preferred operation for future use. The setting will be memorized by the unit for future operation (except airﬂ ow direction).

. Select your preferred operation.

2. Press and hold

3. Press

To automatically restart the conditioner after the power failure (Power of the unit must be on.)

Setting

. Press and hold the RESET button on the indoor unit for 3 seconds to set the

• Do not operate ON timer and OFF timer.

2. Press and hold the RESET button on the indoor unit for 3 seconds to cancel the

To operate at super low fan speed for quiet operation (except in DRY mode)

Press

Note: Under certain conditions, QUIET operation may not provide adequate

To save energy while sleeping, automatically control air ﬂ ow and automatically turn OFF.

Press

Note: The cooling operation, the set temperature will increase automatically

To start the sleep timer (OFF timer) operation Press

SET

Press

: Set the timer. Press

CLR

Press

: Cancel the timer. Press

PressON: Set the ON timer.

OFF

Press

: Set the OFF timer.

otherwise, the time lag of up to 5 minutes will occur.

PRESET OPERATION

PRESET

displays.

PRESET

for 3 seconds to memorize the setting. The P mark

: Operate the preset operation.

AUTO RESTART OPERATION

operation. (3 beep sound and OPERATION lamp blink 5 time/sec for 5 seconds)

operation. (3 beep sound but OPERATION lamp does not blink)

QUIET OPERATION

QUIET

: Start and stop the operation.

cooling or heating due to low sound features.

COMFORT SLEEP OPERATION

COMFORT

SLEEP

: Select , 3, 5 or 9 hrs for OFF timer operation.

 degree/hour for 2 hours (maximum 2 degrees increase). For heating

operation, the set temperature will decrease.

SLEEP TIMER OPERATION

SLEEP

: Select , 3, 5 or 9 hrs for OFF timer operation.

MAINTENANCE

Press

mark ﬂ ashing.

OFF

: Set the desired OFF timer.

SET

: Set the timer.

CLR

: Cancel the timer.

SET

button during the ( or )

SELF CLEANING OPERATION (COOL AND DRY OPERATION ONLY)

To protect bad smell caused by the humidity in the indoor unit.

. If the

continue to run for other 20 minutes, then it will turn off automatically. This will reduce the moisture in the indoor unit.

2. To stop the unit immediately, press the

Note:

• SELF CLEANING operation is default setting from factory.

• To cancel this function, press and hold the reset button on the indoor unit for 20 seconds.

The SELF CLEANING operation will be cancelled. (5 beep sound but

OPERATION lamp does not blink)

• Do the same to set this function again. (5 beep sound and OPERATION lamp blink 5 time/sec for 5 seconds)

• AUTO RESTART operation will be cancelled by setting or cancellation of SELF CLEANING operation. Set it again if necessary.

OPERATION AND PERFORMANCE

. Three-minute protection feature: To prevent the unit from being activated for

3 minutes when suddenly restarted or switched to ON. Preheating operation: Warm up the unit for 5 minutes before the heating operation starts.

3. Warm air control: When the room temperature reaches the set temperature, the fan speed is automatically reduced and the outdoor unit will stop.

4. Automatic defrosting: Fans will stop during defrost operation.

5. Heating capacity: Heat is absorbed from outdoors and released into the room. When the outdoor temperature is too low, use another recommended heating apparatus in combination with the air conditioner. Consideration for accumulated snow: Select the position for outdoor unit where it will

6. not be subjected to snow drifts, accumulation of leaves or other seasonal debris.

Some minor cracking sound may occur when unit operating. This is normal because the cracking sound may be caused by expansion/contraction of plastic.

Note: Item 2 to 6 for Heating model

Air conditioner operating conditions

Operation

Heating –0°C ~ 24°C Less than 27°C Cooling 5°C ~ 43°C 2°C ~ 32°C Dry 5°C ~ 43°C 7°C ~ 32°C

TROUBLESHOOTING (CHECK POINT)

The unit does not operate.

• The power main switch is turned off.

• The circuit breaker is activated to cut off the power supply.

• Stoppage of electric current

• ON timer is set.

REMOTE CONTROL A-B SELECTION

To separate using of remote control for each indoor unit in case of 2 air conditioner are installed nearly.

Remote Control B Setup.

. Press RESET button on the indoor unit to turn the air conditioner ON.

2. Point the remote control at the indoor unit.

3. Push and hold “00” will be shown on the display.

4. Press will disappear and the air conditioner will turn OFF. The Remote Control B is memorized.

Note: . Repeat above step to reset Remote Control

2. Remote Control A has not “A” display.

3. Default setting of Remote Control from

Firstly, turn off the circuit breaker.

Filter Reset (Some models only)

FILTER lamp lights on; the ﬁ lter must be cleaned. To turn off the lamp, push the RESET button on the indoor unit or the FILTER button on the remote control.

Indoor Unit and Remote Control

• Clean the indoor unit and the remote control with a wet cloth when needed.

• No benzine, thinner, polishing powder or chemically-treated duster.

button is pressed once during “Cool” or “Dry” mode, the fan will

3 times within 30 seconds.

Temp.

Outdoor Temperature

Room

Temperature

Cooling or Heating is abnormally low.

• The ﬁ lters are blocked with dust.

• The temperature has been set improperly.

• The windows or doors are opened.

• The air inlet or outlet of the outdoor unit is blocked.

• The fan speed is too low.

• The operation mode is FAN or DRY.

CHK O

button on the Remote Control by the tip of the pencil.

MODE

during pushing

CHK O

. “B” will show on the display and “00”

to be A.

factory is A.

025045-24Lang.indb 3

/9/09 2:46:06 PM

+ 6 hidden pages