Toshiba G00J119 Service Note

BSINo. G00J119 Page 1

BSI No.: G00J119
Publish

2000/10/06

Date:
Subject: Countermeasure to Prevent Exposure Lamp Breakage (Carriage)

Model: DP4580, DP5570, DP6570, DP8070

Category Field Application UNIT

Countermeasure to field trouble To be applied when necessary Optical

FactoryApplication: Applicable from June A, 2000 at the factory

CONTENT

To prevent the breakage of the exposure lamp in a specified market (Japan), cushion material has been
added as follows.

[Changed/ Added Part No.]

MODEL P-I Before Change After Change Note P I R

A - J -

DP4580

39-3
7

------ 4406318590
RUBBER-CR-30

DP5570
DP6570
DP8070

P-I: Page-Item P: Contents of Change I: Interchangeability R: Reasons for Change

<Caution>
When the carriage is to be readjusted, this can only be done after the added cushion material is
removed. Be sure to fix the cushion material according to the attached file after adjustment.

FAA

<Reference>
The screw position for the copier packing has been changed by addtion of this cushion. But this
causes no problems.

Attached File

G00J119.pdf

Related Documents:

LinkTo: Link From:

BSINo. G00J119 Page 2

1. Fix when adjusting the position of the carriages1 and 2.

z Refer to the “Service Handbook ”.

2. Attach the cushion material based on the following instructions.

z Cushion material: 2 places

z Be sure to absorb the attaching face.

Addition of cushion material

Cushion material attaching pointCushion material attaching point

Window

　ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｒ

ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｒ　　　　　　　　　　　　　　　　　　　　　　　　　　　　ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｆ

ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－ＲＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｒ

　　　　　　　　Window

　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　(Face-to-face)

　　　　　　　　　　　　　　 　　　　　　　　　　Rubber isolator

（２０）

Edge face alignment

（７ｍｍ）

（７ｍｍ）

（７ｍｍ）（７ｍｍ）

ＡＳＭ－ＦＲＭ－Ｒ－ＳＣＡＮ

Edge alignment

Window

ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｆ

ＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－ＦＡＳＭ－ＲＡＩＬ－ＳＣＡＮ－Ｆ