Toshiba 32AFX54CD Schematic

CIRCUIT DIAGRAMS

32AFX54

Color Television

32AF44

FILE NO. 020-200402

DOCUMENT CREATED IN JAPAN, July, 2004

SCHEMATIC DIAGRAM

MODEL : 32AF44/32AFX54

WARNING: BEFORE SERVICING THIS CHASSIS, READ THE "X-RAY RADIATION PRECAUTION", "SAFETY
PRECAUTION" AND "PRODUCT SAFETY NOTICE" ON THE MANUAL FOR THIS MODEL.

CAUTION: The international hazard symbols " " in the schematic diagram and the parts list designate components
which have special characteristics important for safety and should be replaced only with types identical to those in the
original circuit or specified in the parts list. The mounting position of replacements is to be identical with originals.
Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for this
model. Do not degrade the safety of the receiver through improper servicing.

NOTE:

1. RESISTOR Resistance is shown in ohm [K = 1.000, M = 1.000.000]. All resistors are 1/6W and 5% tolerance
carbon resistor, unless otherwise noted as the following marks.
1/2R = Metal or Metal oxide of 1/2 watt 1/2S = Carbon compsistion of 1/2 watt
1RF = Fuse resistor of 1 watt 10W = Cement of 10 watt

±

10% G = ±2% F = ±1%

K =

2. CAPACITOR Unless otherwise noted in schematic, all capacitor values less than 1 are expressed in
the values more than 1 in pF.
All capacitors are ceramic 50V, unless otherwise noted as the following marks.

Electolytic capacitor

Mylar capacitor

µ

F, and

3. The parts indicated with "

4. Voltages read with DIGITAL MULTI-METER from point indicated to chassing ground, using a color bar signal with

all controls at normal, line voltage at 220 volts.

5. Waveforms are taken receiving color bar signal with enough sensitivity.

6. Voltage reading shown are nominal values and may vary

SCHEMATIC DIAGRAM STRUCTURE:

MAIN Circuit
SUB Circuit
IF Circuit
FRONT Circuit

CRT-D MAIN Circuit

..................................................................................................................... 2/6

......................................................................................................................... 3/6

" have special characteristics, and should be replaced with identical parts only.

±

20% except H.V.

.................................................................................................................... 1/6

(1/2) [ SHEET - 1/2] .............. 4/6

(2/2) [ SHEET - 2/2] .............. 5/6

....................................................................................................... 6/6

QG01

DIG Comb

ZY01

PIP

Module

CIRCUIT BLOCK DIAGRAM