Toro DL2000 Series PC Dripline Sell Sheet
DL2000® Series
PC Dripline
Landscape Drip
Toro® DL2000 Dripline is the most technologically advanced
subsurface irrigation system available. Through its non-toxic
ROOTGUARD® technology, only DL2000 delivers optimal
water application directly to the root zone while safely
inhibiting root intrusion. Unlike other subsurface systems,
DL2000 requires virtually no maintenance. There are no filters
to change or chemically treated disks to handle. Ideal for shrub
areas, median strips, public recreation areas and parking
islands, DL2000 eliminates overspray and run-off since water
is applied only at the root zone.
Features & Benefits
US Government-approved
ROOTGUARD Protection
The pre-emergent, TREFLAN®, is impregnated into the
emitter during the molding process and creates a “force
field” effect around the emitter outlet, diverting root
growth and assuring long term reliability.
Effluent
Options
Available
At Grade Or Buried Options
Can be installed at grade or buried 4” – 8” underground,
delivering irrigation directly to the plant’s root zone.
Pressure Compensating PC Self-cleaning Emitters
Provide precise, trouble-free water application. TREFLAN®
impregnated emitters are inseparably welded to the inside
wall of durable polyethylene dripline tubing during
manufacturing.
Environmentally Friendly
Irrigation takes place at or below grade so there is minimal water loss due to mist, evaporation, run-off or wind.
Fertigation needs are reduced because water is applied
only at the root zone. Safety is assured because the treated
emitters are inside the DL2000 tubing.
Safety and Liability
When DL2000 is installed below ground, the landscape
surface is free from irrigation equipment that may disrupt
activities or cause injury. Sub-surface performance also
avoids slippery walkways and roadways as well as wet
walls, fences and windows.
Online Design Guide Available.
Visit: www.toro.com/DL2000
DL2000® Series PC Dripline
DL2000 5/8"
1.20
1.00
0.80
0.60
Flow rate (gph)
0.40
0.20
0.00
0510 15 20 25 30 35 40 45 50 55 60
Flow Rate .53/1.06 GPH
Coefficient of Variation (Cv) ≤ 5%
Flow Exponent (x) 0.05
Inside Diameter 0.620”
Outside Diameter 0.710”
Wall 0.045”
Operating pressure (P) 15–60 psi
Minimum filtration requirement 120 Mesh
Hazen-Williams C factor 140
Barb loss factor (Kd) .98
0.99
0.96
0.52
0.53
Specifications
5/8” DL 2000 PC DRIPLINE with ROOTGUARD
Model Description
• RGP-212-01
• RGP-412-01
• RGP-218-01
• RGP-418-01
• RGP-212-05
• RGP-412-05
• RGP-218-05
• RGP-418-05
• RGP-212-10
• RGP-412-10
• RGP-218-10
• RGP-418-10
5/8” DL2000 PC PURPLE DRIPLINE with ROOTGUARD
Model Description
• RGP-212-05-E
• RGP-412-05-E
• RGP-218-05-E
• RGP-418-05-E
Other Features
• Design exibility for narrow, odd-shaped landscape areas
• Precise watering puts water where it’s needed; avoids water
marks on expensive hardscapes, glass or signage
• Distinctive red strip on tubing signies DL2000 w/ROOTGUARD®
Warranty
Seven years
Emitter Discharge Rate vs. Pressure
1.07
1.06
1.05
1.04
1.03
1.01
0.55
0.55
0.55
0.55
0.54
0.54
Pressure in psi
1.08
0.56
Performance Table
0.50 GPH, 12” emitter spacing, 100 ft. coil
1.00 GPH, 12” emitter spacing, 100 ft. coil
0.50 GPH, 18” emitter spacing, 100 ft. coil
1.00 GPH, 18” emitter spacing, 100 ft. coil
0.50 GPH, 12” emitter spacing, 500 ft. coil
1.00 GPH, 12” emitter spacing, 500 ft. coil
0.50 GPH, 18” emitter spacing, 500 ft. coil
1.00 GPH, 18” emitter spacing, 500 ft. coil
0.50 GPH, 12” emitter spacing, 1000 ft. coil
1.00 GPH, 12” emitter spacing, 1000 ft. coil
0.50 GPH, 18” emitter spacing, 1000 ft. coil
1.00 GPH, 18” emitter spacing, 1000 ft. coil
0.50 GPH, 12” emitter spacing, 500 ft. coil
1.00 GPH, 12” emitter spacing, 500 ft. coil
0.50 GPH, 18” emitter spacing, 500 ft. coil
1.00 GPH, 18” emitter spacing, 500 ft. coil
1.09
0.56
0.53 gph (2 lph)
1.06 gph (4 lph)
Air/Vacuum
Relief Valve
(Part No. T-YD–500–34)
Flush Valve
(Part No.T- FCH–H)
Dripline
Emitter
Water Source
Filter
(Part Nos.
T-ALFD75150–L)
Control
Valve
Pressure Regulator
(Part Nos. T-PMR15–LF,
T-PMR25–LF, T-PMR40–MF,
T-PMR25–HF & T-PMR25–MF)
Tee
(Part No.T- FTT16)
Elbow
(Part No. T-FEE16)
Also Available as a
Drip Zone Valve Kit.
Other fittings available:
• Coupling
(Part No. T-FCC16)
• Adapter (Part No. T-FAM16)
• Compression Adapter (Part No. T-CA-710)
5/8” (.0620” ID X 0.710” OD
Part No.
RGP-212 .53 12” 250’ 360’ 400’ 460’
RGP-218 .53 18” 350’ 515’ 565’ 650’
RGP-412 1.0 12” 160’ 240’ 260’ 300’
RGP-418 1.0 18” 240’ 340’ 375’ 430’
Flow Rate
(GPH)
Emitter
Spacing
Inlet Pressure VS Maximum
Length of Run In Feet
15 psi 25 psi 30 psi 40 psi
Specifying Information—DL2000
RGP X-XX-XX-E
Emitter Flow Emitter
X XX XX E
2—.50 GPH
4—1.0 GPH
Example: A 500’ coil of Pressure-compensating Dripline with ROOTGUARD,
12” emitter spacing and 0.5 GPH (2.0 LPH), would be specified as: RGP-212-05
Spacing
12—12”
18—18”
Note: Specify/use Loc-Eze Fittings or .710 Compression Fittings
Coil Length Optional
01—100’
05—500’
10—1000’
E—Purple Tubing
for Non-potable
Water
www.toro.com • The Toro Company • Irrigation Division • 5825 Jasmine St. • Riverside, CA • 92504 • 877-345-8676
Specications subject to change without notice. For more information, contact your local Toro distributor. P/N 13-1061-IRC
©2013 The Toro Company. All rights reserved.
Loading...