Toro 79271 Setup Instructions

FORM NO. 3316–873

Cable Replacement Instructions

for 48” Snow Blade

MODEL NO. 79271 - 4900001 & UP
MODEL NO. 99271 - 4900001 & UP

MODEL NO. 9861915 - T4P0001 & UP

SUPPLEMENT

SHEET

After the blade and index lever have been assembled, replace the existing upper cable on the index lever with the
13 inch long one provided in this kit.

Loose Parts

DESCRIPTION QTY. USE

Cable (13 inch) 1 Replace existing (11 inch) upper cable

Replace Upper Cable

1. Remove the existing upper cable by loosening

jam nut, unthreading from turnbuckle and
unhooking “Z” end from release lever.

2. Remove the jam nut from the existing cable and

transfer to the new cable, threading on all the
way.

5

3

1

4

2

3. Hook “Z” end of new (13 inch) cable into outer

hole of the release lever (Fig. 1).

4. Install threaded end of cable into turnbuckle

(Fig. 1).

5. Adjust turnbuckle so the index pin is pulled out

of channel when the release lever is squeezed,
for easy side-to-side movement (Fig. 1).

6. Tighten jam nut securely (Fig. 1).

Printed in USA

1. Upper Cable

2. Turnbuckle

3. “Z” End

1472

Figure 1

4. Jam Nut

5. Release Lever