Toro 79214, 79215 Addendum

38 and 42 Twin Bagger

TimeCutter Z Attachment

Model No. 79214—230000001 and Up Model No. 79215—230000001 and Up

Important The following instructions are updates for

the Setup instructions in the Twin Bagger Manual.

Installing the Front Weight

Form No. 3329–822

Addendum

Caution

The bagger adds a lot of weight to the rear of the machine and may cause an unstable condition which could result in a loss of control.

• Install the front weight.

Installing the front weight procedure can be done at anytime during the setup.

1. Lift up the footrest and temporarily remove it from the

machine (Fig. 1).

m–6423

Figure 1

1. Footrest

2. Rod

3. Hole positions

m–6686

Figure 2

1. Footrest frame

2. Bolt, 3/8 x 2–1/4 inch

3. Front weight

4. Washer, 3/8 inch

5. Nut, 3/8 inch

Important When you remove the twin bagger,

remember to remove the front weight.

Assembling the Bagger

Note: If the frame assembly is not installed to the bagger cover, use the following instructions for installing it.

1. Install the frame assembly to the bagger cover with 2

locknuts (1/4 in.) (Fig. 3).

2. Install the front weight to the bottom footrest frame

with 2 bolts (3/8 x 2–1/4 inch), 4 washers (3/8 inch) and 2 nuts (3/8 inch) (Figure 2).

Note: Make sure the weight is installed as shown in Figure 2.

3. Install the footrest into the footrest frame while placing

the rods in the same hole positions (Fig. 1).

 2003 by The Toro Company 8111 Lyndale Avenue South Bloomington, MN 55420-1196

1. Frame assembly

2. Bagger cover

1849

Figure 3

3. Locknut, 1/4 in.

Printed in the USA