Toro 74-1190 Installation Instructions
FORM NO. 3314-203 REV C
PART NO. 74-1190
WEIGHT KIT FOR POWER SHIFT SNOWTHROWERS
(Models 38500, 38505, 38510, 38513, 38520, 38525, 38540, 38543, 38545,
38555, 38556, 38565, 38566, 38570, 38573, 38574, 38580, 38590, 38591)
The weight kit is required for the 624, 824, 828 and
1028 Power Shift snowthrowers when the optional
cab is installed (also recommended for 1132 and
1232 Power Shift snowthrowers). The kit helps pre
vent the front end of the snowthrower from riding up
when wheels are in the forward position.
KIT CONTAINS:
Weight bar - (1)
Bolts - (2)
Washers - (2)
Nuts - (2)
INSTALLING WEIGHT BAR ON 624 AND
824 POWER SHIFT SNOWTHROWERS (Fig. 1)
1. Stop engine and remove wire from spark plug.
2. Loosen and remove front (2) bolts and (2) nuts
from top of auger housing.
INSTALLATION
INSTRUCTIONS
4. Secure weight bar securely to auger housing
with (2) bolts, (2) washers, and (2) nuts provided
with kit.
5. Reinstall spark plug wire.
INSTALLING WEIGHT BAR ON 828, 1028, 1132 and
1232 POWER SHIFT SNOWTHROWERS (Fig. 2)
Two holes will need to be drilled in auger housing to
attach weight bar.
1. Stop engine and remove wire from spark plug.
2. To correctly position weight bar, center bar on
top of auger housing so that thinner side points to
ward front of auger housing. Align holes in weight
bar with front two auger housing bolts. Thin side of
weight bar should be even with bend in auger hous
ing. Mark locations where two holes need to be
drilled.
WEIGHT
BAR
BOLT
WASHER
DANGER
DECAL
NUT
Figure 1
3. Position weight bar on top of auger housing so
that the thinner side points toward the front of the
auger housing. Align holes in weight bar with front
holes in auger housing.
753
WEIGHT
BAR
HOLE
BOLT
WASHER
DANGER
DECAL
HOLE
NUT
752
Figure 2
3. Drill two 11/32" diameter holes in auger housing.
4. Secure the weight bar securely to the auger
housing with (2) bolts, (2) washers, and (2) nuts pro
vided with the kit.
NOTE: The danger decal must be facing up/visible.
NOTE: The danger decal must be facing up/visible.
5. Reinstall spark plug wire.
TPSThe Toro Company - 1990, Rev. 1993, 1997
Loading...