Toro 132-3146 Parts Catalogue
Form No. 0453-720
Arctic Cat® Prowler
Installation Instructions - Accessory Kit
2-Piece Roof Kit
(1436-519)
NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Kit includes:
p/n QTY DESCRIPTION
2441-225 2 Roof Bracket
1441-970 1 Rubber Extrusion
* 10 Fender Washer
* 10 Flange Lock Nut
* 10 Torx Screw (M6)
* 4 Truss Head Screw
* 4 Low Profile Lock Nut
2441-224 6 Rubber Clamp
2441-226 1 Edge Trim
1441-976 2 End Cap
0453-720 1 Instruction
* Included in Hardware Kit (p/n 1436-571)
1. Install End Cap (A) to the front Left- and Right-Side
Roof using two Truss-Head Screws and two Low Profile Lock Nuts; then slide Rubber Extrusion (B) in
between the two roof pieces until it is completely
installed; then install another end cap in the rear using
two truss-head screws and two low-profile lock nuts.
See Fig. 1.
Fig. 1
2. Align both Roof Brackets (A) with the holes on the
under-side of the assembled roof. Insert four M6 Torx
Screws and four Fender Washers through the top of the
roof and the roof brackets. Fasten using four Flange
Lock Nuts. See Fig. 2.
Fig. 2
UTV-123A
NOTE: Place and align the roof onto the ROPS
frame to find proper location for Edge Trim; then
remove paper backing from edge trim and install
on top of front ROPS tube to seal between roof and
the front ROPS tube. See Fig. 3.
UTV-274A
Fig. 3
UTV-275A
3. Place and align the assembled roof properly over the
ROPS frame. Install six Rubber Clamps (A) on the
ROPS bars so that they are aligned with the mount
holes. See Fig. 4.
Fig. 4
UTV-123B
4. Insert six M6 Torx Screws and six M6 Fender
Washers through the top of the roof and into the six
rubber clamps; then fasten using six M6 Flange
Nuts (the rear mount straps will also pass through
the rear panel).
5. Once optimal fitment is achieved, tighten all hardware.
Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 1210
Loading...