Toro 132-3140 Parts Catalogue
Form No. 0453-791
Arctic Cat® Prowler
Installation Instructions - Accessory Kit
Roof Stereo Kit
(p/n 1436-635, 1436-837)
NOTE: Read these installation instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Kit includes:
p/n QTY DESCRIPTION
0430-114 1 Radio
0430-108 1 Jumper Harness
0486-285 1 Main Harness
0423-609 1 Machine Screw (Strap Mount)
8427-605 1 Nut
0453-791 1 Instructions
NOTE: If installing Stereo Kit in a Headliner Kit
(p/n 1436-103) refer to the 1436-104 instructions.
1. Remove the LXC Roof from the vehicle (if
needed).
2. Using the Speaker manufacture's instructions,
cut out each template and place it in the center
of each speaker boss; then cut each hole using
an appropriate tool. See Fig. 1.
Fig. 1
Fig. 2
UTV-347A
4. Remove the stereo din sleeve from Stereo, then
using a white marker, mark the LXC Roof (p/n
1436-500) using the stereo din sleeve as a template.
NOTE: Make sure the area marked is not larger
than the sleeve or the sleeve will not fit properly.
5. Using a suitable tool, cut along the marked area.
6. Using a suitable tool, remove enough area in the
bottom middle rear portion of the stereo din
sleeve. Insert Stereo Strap through the sleeve
and bend approximately 1/2-in. around the
sleeve. See Fig. 3 and 4.
UTV-348
3. Follow the Antenna manufacturer's instructions
for installing the antenna. Arctic Cat recommends installing the antenna in location shown
below. See Fig. 2.
Fig. 3
UTV-315A
Fig. 3
UTV-351
7. Locate the center mounting location (A) where
the windshield mounts to the roof; then using a
3/16-in. drill bit, drill a hole aligned with the
center mounting location. See Fig. 4 and 5.
Fig. 4
9. Secure the back of the stereo by installing Strap
Mount Machine Screw through the hole in the
roof (drill in step 5) and through the closest hole
in the stereo strap and secure using a Nut.
Tighten until snug.
NOTE: Before installing the speakers, be sure to
drill a hole in the rear right-side corner so the
accessory plug can be routed through. See Fig. 7.
Fig. 7
UTV-345
10. Route the Harness to each speaker location; then
install the speaker clips onto the edge of the
speaker mounting locations. Tape the clips in
place to aid the installation. See Fig. 8.
UTV-317A
Fig. 5
UTV-152B
8. Follow the stereo manufacturer’s instructions for
installing the stereo din sleeve. Make sure all
tabs are bent so the sleeve is secured to the roof.
See Fig. 6.
Fig. 6
Fig. 8
UTV-344
11. Connect the speaker wires to the speakers and
secure using the supplied screws; then install the
speaker screens. See Fig. 9.
Fig. 9
UTV-346
UTV-350
Loading...