Toro 132-3131 Parts Catalogue
Form No. 0453-421
Arctic Cat® Prowler
Installation Instructions - Accessory Kit
Front Brushguard Bumper Kit
(p/n 0436-992)
NOTE: Read these installation instructions thoroughly before beginning the installation process. Retain
these Installation Instructions for future reference.
Application: All Prowler Models
Kit includes:
p/n QTY DESCRIPTION
0541-559 1 Brushguard Bumper
0541-417 2 Pin (J-Shaped)*
0423-615 2 Spring *
0423-614 2 E-Clip*
8432-802 2 Nyloc Nut (8 mm)*
0423-073 2 Flat Washer (1.38 OD x 0.413 ID)*
0423-505 2 Shoulder Screw
0453-421 1 Instructions
*Included in Hardware Kit (p/n 0436-950)
Fig. 1
0742-702
NOTE: To install the brush guard on certain
Prowlers equipped with stock bumpers, it is necessary to enlarge the bumper mounting holes. See
steps 1 and 2; otherwise skip to step 3.
1. Using a 13 mm and a 10 mm wrench, remove the
four cap screws securing the existing front bumper. Remove the bumper and discard the existing
hardware.
2. Enlarge the four outside and two lower inside
mounting holes in the bumper mounting tubes
using a 15 mm (19/32 in.) drill bit See Fig. 1.
3. Position the new Brushguard Bumper onto the
front of the vehicle. From the outside, insert the
two Shoulder Screws (A) through the lower
mounting holes in the bumper bracket. Place a Flat
Washer (B) onto each shoulder screw; then secure
with Nyloc Nut (C). See Fig. 2 for identification
and location of parts.
NOTE: There may be extra hardware included in
this kit. Only the 1.38 in. x 0.413 in. flat washers are
to be used. Discard extra washers.
Fig. 2
0742-701
NOTE: Do not over-tighten. The bumper will need
to move freely in order to rotate the bumper downward to gain access to the hood.
4. Position the bumper at a downward angle; then
insert Spring (D) centered in the mounting
bracket; then align the spring with the upper
mounting lower holes in the brackets.
5. From the outside, insert Pin (E) through the
bracket mounting and into the spring. While carefully pulling backward on the spring to compress
it, install E-Clip (F) into the groove at the end of
the pin to secure the pin.
CAUTION
Be sure to wear safety glasses when compressing
the spring and installing the E-Clip.
6. Pull outward on the pin and move it forward to the
unlocked position.
7. Repeat steps 4-6 for the opposite side.
8. Raise the bumper into position; then pull outward
on the pin and rotate the pin backward and lock the
J-end into the locked position.
Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 0613
Loading...