Toro 114-0250 Installation Instructions
Form No. 3358-133 Rev A
Jackshaft Assembly Kit
For Z Master® Riding Mowers with Daihatsu Engines
Model No. 114–0250
Installation Instructions
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
2
No parts required
Three stacked pulleys
Top bracket (round hole on top)
Bottom bracket (square hole on
top)
Plastic cap
Nut, (5/8 inch)
Spacer
Flanged spacer
Bolt, (3/8 x 1-1/4 inches)
Bolt, (3/8 x 1 inch)
Curved washer, (7/16 inch)
Locknut, (3/8 inch)
Carriage bolt, (5/8 x 4 inches)
Description
Qty.
–
1
1
1
1
1
1
1
1
4
5
5
1
Remove the existing pulleys.
Install the new pulleys.
Use
Step
1
Removing the Existing
Pulleys
No Parts Required
Procedure
1. Stop the engine , set the parking brak e , w ait
for all mo ving par ts to stop , and remo v e the
ignition k ey .
2. R emo v e the tw o dri v e belts and the mo w er
dec k belt from the three stac k ed pulleys .
R efer to the Operator’ s Manual for the cor rect
procedure .
3. R emo v e the three stac k ed pulleys from the
bearing housing ( Figure 1 ).
© 2007—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Figure 1
1. Bolt 3. Washer
2. Three stacked pulleys
4. Nut
4. R emo v e the bearing housing from the mo w er
dec k ( Figure 2 ).
Step
2
Installing the New Pulleys
Parts needed for this step:
1
Three stacked pulleys
1
Top bracket (round hole on top)
1
Bottom bracket (square hole on top)
1
Plastic cap
1
Nut, (5/8 inch)
1
Spacer
1
Flanged spacer
1
Bolt, (3/8 x 1-1/4 inches)
4
Bolt, (3/8 x 1 inch)
5
Curved washer, (7/16 inch)
5
Locknut, (3/8 inch)
1
Carriage bolt, (5/8 x 4 inches)
Procedure
1. Install the bottom brac k et (square hole on top)
to the mo w er dec k with 2 bolts (3/8 x 1 inc h),
2 cur v ed w ashers , and 2 loc kn uts (3/8 inc h)
( Figure 3 ).
Figure 2
1. Bearing housing 3. Washer
2. Belt guide bracket 4. Bolt
Figure 3
1. Locknuts (3/8 inch)
2. Bottom bracket (square
hole on top)
3. Curved washer
4. Locknuts (3/8 inch)
2. Install the top brac k et (round hole on top) and
the belt guide brac k et to the mo w er dec k with
a bolt (3/8 x 1-1/4 inc hes) in the top hole of
the belt guide brac k et, 2 bolts (3/8 x 1 inc h),
3 cur v ed w ashers , and 3 loc kn uts (3/8 inc h)
( Figure 4 ).
2
Loading...