Toro 104-6663 Installation Instructions
Horn Kit
Workman 1 100/2100 and Twister Utility Vehicle
Part No. 104-6663
Loose Parts
Description Qty. Use
Form No. 3326-973
Installation Instructions
Horn
U-bolt
Locknut, 3/8 in.
Plate
Harness
Horn button
Decal 1 Attach to the dash panel.
Certificate of compliance 1
Installation Instructions 1 Assembling the Horn Kit
1
1
2
1
1
1
Installing the horn
Installing the harness
Attaching the Horn
1. Position the machine on a level surface. Set the
parking brake, stop the engine, and remove the key.
Caution
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
2. Remove the hood from the vehicle by removing the 2
screws in the top of the hood, the 2 bolts on each
fender, and the 4 bolts from the bottom of the hood.
3. Attach the horn to the frame channel with the U-bolt,
plate, and locknuts (Fig. 1).
1. Horn
2. U-bolt
4
4
1
3
2
m–5674
Figure 1
3. Plate
4. Locknut
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
All Rights Reserved
1
Printed in the USA
4. Locate, mark, and drill a 0.641 diameter hole in the
dash panel at the location shown in Figure 2.
Workman 1100/2100 with Serial Numbers
22000000001 and Higher
1-3/8 in.
5/32 in.
(4 mm)
2
Figure 2
1. 0.641 diameter hole 2. Decal
5. Secure the horn button to the dash panel.
6. Attach the decal to the dash in the approximate
location shown in Figure 2.
(35 mm)
1
m–5675
1. Connect the short violet wire from the horn harness to
the violet pigtail on the vehicle harness.
2. Connect the short black wire from the horn harness to
the black pigtail on the vehicle harness.
3. Install the hood.
Twister with Serial Numbers 21099999999
and Lower
1. Unplug the red or yellow wire from the vehicle
harness to the ignition switch.
2. Unplug the black wire from the vehicle harness to the
ignition switch.
3. Connect the short violet and black wires from the horn
harness to the ignition switch.
4. Connect the red or yellow wire from the vehicle
harness to the violet plug on the horn harness.
5. Connect the black wire from the vehicle harness to the
black plug on the horn harness.
6. Install the hood.
Connecting the Wire Harness
1. Connect the white and long black wires on the wire
harness to the horn.
2. Connect the ring terminals to the horn button.
Workman 1100/2100 with Serial Numbers
210999999 and Lower
1. Unplug the violet and black wires from the vehicle
harness to the the ignition switch.
2. Connect the short violet and black wires from the horn
harness to the ignition switch.
3. Connect the violet wire from the vehicle harness to the
violet plug on the horn harness.
4. Connect the black wire from the vehicle harness to the
black plug on the horn harness.
5. Install the hood.
Twister with Serial Numbers 220000001
and Higher
1. Connect the short violet wire from the horn harness to
the yellow pigtail on the vehicle harness.
2. Connect the short black wire from the horn harness to
the black pigtail on the vehicle harness.
3. Install the hood.
2
Loading...