Topcon WT11EC Users Manual

WT11EC USER’S MANUAL

Over V iew

This device is a class 1,Bluetooth® 2.0+EDR (Enhanced Data Rates)module.

Physical Specifications

Table A-1 Physical Specification

 Dimensions W: 43mm D: 20mm H: 4.3mm

Weight 4g

Input / output UART interface/Power/antenna

Input voltage 3.3V±5%
Operating temperature -40 to +85℃
Storage temperature -40 to +85℃

Wireless specifications

Table A-2 Wireless Specifications

Standard Bluetooth Version 2.0 Class 1
Frequency modulation technique T GFSK(1Mbps), π/4 DQPSK(2Mbps), 8DPSK(3Mbps)

Hopping 1600hops,1MHz channel space
Frequency Range 2404-2478MHz
Output power 12dBm

Installation Guide

1. Module connected to UART Port on the mother Board in your Equipment. (see below)

Antenna

Top Vie w

Bottom View

Connect to UARTPort

UART Port

NAME SPEC MODEL

Mother Board

I/F Connecter UART Port DF16-40DP-0.5v

RF Connector

*We are preparing driver software.
Confirm the homepage of Microsoft to the method of installing the driver software.
You must make sure that 20cm minimum separation is maintained between users and the antenna.

Antenna coaxial connector

U.FL-R-SMT

Warning

Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.

Regulatory Information

Compliance statement to FCC/IC

This module complies with part 15 of the FCC rules and IC RSS-210.
Operation is subject to the following conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.

RF exposure compliance

1) To comply with FCC/IC RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between the antenna of this device and all persons.

2) This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.

Requirements to end product

This module must be integrated only by OEM integrators under the following conditions.

(1) OEM integrator has to be aware not provide information to the users regarding how to install or

remove this module in the users manual of the end product which integrate this module.
Installation by end users is strictly prohibited.

(2) Antenna

OEM integrator shall use this module without any modifications including antenna.
If module integrator uses a unique antenna, the FCC certification is required for the end
product.
OEM integrator must make sure that 20cm minimum separation is maintained between users
and the antenna.

(3) Co-location.

This module must not be co-located or operated in conjunction with any other antenna or
transmitter. The module integrator shall obtain FCC approval for the end product, if the module
is used for co-location operation.

(4) Markings

To satisfy FCC/IC exterior labeling requirements, the following text must be placed on the
exterior of the end product.

Contains Module FCC ID: H5P-WT11EC, IC: 6050A-WT11EC

Any similar wording that expresses the same meaning may be used.

(5) Caution to user for modification

The following caution is expressed on the user’s instruction manual.

The changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the device.

(6) Compliance statement to FCC

The following statement is expressed on the user’s instruction manual.